689491
15
Zoom out
Zoom in
Previous page
1/125
Next page
-1.1-
1 OPERATIONAL OVERVIEW
1.1 Turning on the Power
The [POWER] switch is located at the left corner of the display unit. Push it to switch on the radar
set. To turn off the radar, push it again. The screen shows the bearing scale and digital timer
approximately 15 seconds after power-on. The timer counts down three minutes of warm-up time.
During this period the magnetron, that is, the transmitter tube, is warmed for transmission. When
the timer has reached 0:00, the indication STBY appears, indicating that the radar is now ready to
transmit pulses.
Switch S2
Notice for technicians
The display unit designed to run on AC voltage
has a switch (S2) at its rear to cut off 115/230 V
supply from internal circuits. Thus, the radar will
not operate when this switch is turned off. Keep it
in the ON position.
1.2 Transmitter ON
After the power is turned on and the magnetron has warmed up, STBY appears at the screen
center, indicating the radar is ready to transmit radar pulses. Press the [STBY/TX] key to transmit.
When you won’t be using the radar for an extended period, but you want to keep it in a state of
readiness, place it in standby by pressing the [STBY/TX] key. The display shows STBY.
Video Freeze-up Recovery
Video freeze-up or lock-up can occur unexpectedly on any digital rasterscan radars. This is
mainly caused by heavy spike noise in the power line and can be noticed by carefully watching
the nearly visible sweep line. If you suspect that the picture is not updated every scan of the
antenna or no key entry is accepted notwithstanding the apparently normal pictures, do Quick
Start to restore normal operation.
.1 Turn off the Power Switch and within 10 seconds turn it on again.
.2 Press the Transmit switch labeled STBY/TX for transmit condition.
POWER
switch
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Furuno FR1510 MARK-3 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Furuno FR1510 MARK-3 in the language / languages: English as an attachment in your email.

The manual is 1,58 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Furuno FR1510 MARK-3

Furuno FR1510 MARK-3 Installation Guide - English - 75 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info