616299
12
Zoom out
Zoom in
Previous page
1/89
Next page
1-4
1.1.3 Fastening the antenna unit to the mounting platform
The antenna unit may be assembled before hoisting it to the mounting platform. However, do
not lift the antenna unit by the radiator. Always hold the unit by its housing. When using a crane
or hoist, lift the unit by the hoist rings which should be fastened to the bolt fixing covers of the
antenna housing.
CAUTION
DO NOT hoist the antenna unit by the
radiator; hoist it by the hoist rings. (Be sure to
remove rings after hoisting the antenna unit.)
Hoist
ring
NO!
1. Construct a suitable mounting platform referring to the outline drawing at the back of the
manual.
2. Drill four mounting holes of 15 mm diameter and one cable entry hole of about 50 mm
diameter in the mounting platform.
3. Lay the rubber mat (supplied) on the mounting platform.
4. Place the antenna unit on the rubber mat orienting the unit so the bow mark on its base is
facing the ship's bow.
Ground terminal
Rubber mat
Bow mark
Figure 1-3 Antenna unit, front view
5. Fasten the antenna unit to the mounting platform with four sets of M12X60 hex bolts, nuts,
flat washers and seal washers (supplied).
6. Using hex bolt (M6X25), nut (M6) and flat washer (M6), establish the ground system on the
mounting platform as shown in Figure 1-4. The location should be within 370 mm of the
ground terminal on the antenna unit. Connect the ground wire (RW-4747, 370 mm, supplied)
between the grounding point and ground terminal on the antenna unit. Coat the entire
ground system with silicone sealant (supplied).
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Furuno FR-2125-B at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Furuno FR-2125-B in the language / languages: English as an attachment in your email.

The manual is 4,38 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info