522208
29
Zoom out
Zoom in
Previous page
1/45
Next page
3. INSTALLATION
21
Turn on the terminal resistor in the junction box when the NMEA 2000
sensor(s) connected to it do not have a terminal resistor.
For how to turn on the terminal resistor in a FI-50 series instrument, see
page 33 (FI-501//FI-502/FI-505) or page 35 (FI-506).
3.4 Setting Up
Your instrument is pre-programmed with factory default settings, which
may or may not be suited to your vessel. Therefore, it is necessary to ini-
tialize the instrument for use with your vessel. This should be done im-
mediately after completion of the installation.
Two sets of setup menus are provided: setup1 and setup2. The setup1
menu provides system parameters and the setup2 menu has user set-
tings.
3.4.1 Setup1 menu
The setup1 menu contains system parameters which optimize the instru-
ment for use on your vessel. Follow the procedure below to access and
set parameters.
1. Press the APP/TRUE and SELECT/CLEAR keys momentarily to
enable the setup1 menu. The Depth unit selection screen appears,
with the depth unit flashing. (See the illustration on the next page.)
2. Use the DISP key to select a menu item. Each press of the key
changes the menu item in the sequence shown in the illustration on
the next page.
Terminal Resistor
OFF:
ON:
29


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Furuno FI-504 MULTI at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Furuno FI-504 MULTI in the language / languages: English as an attachment in your email.

The manual is 0,93 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info