522181
16
Zoom out
Zoom in
Previous page
1/40
Next page
1. MOUNTING
7
1.5 Optional Temperature Sensors
1.5.1 Transom mount temperature sensor T-02MTB
Fix the cable at a convenient location with cable clamp.
When the cable is led in through the transom board, make a hole of approx. 17 mm (0.7”) in
diameter to pass the connector. After passing the cable, fill the hole with a sealing compound.
1.5.2 Thru-hill temperature sensor T-02MSB, T-03MSB
Select a suitable mounting location considering the following points:
Select a mid-boat flat position. The sensor does not have to be installed perfectly perpendicular.
However, the location should not be such that the transducer may be damaged when the boat
is dry-docked.
Locate away from equipment which gives off heat.
Locate away from drain pipes.
Select a location where vibration is minimal.
123mm (4.8”)
51
Brim
ø77
Locknut
Face “notch”
toward bow.
Flange nut
Coat with
silicone
lt
(3 0”)
(2.0”)
D
Mount sensor flush with
hull bottom.
M5x20
D>50 cm (20.0”)
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Furuno BBDS1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Furuno BBDS1 in the language / languages: English as an attachment in your email.

The manual is 3,62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info