28328
30
Zoom out
Zoom in
Previous page
1/43
Next page
3. INSTALLATION
23
Flat
washer
Antenna base
assy.
Spring
washer
Platform
Hex bolt
(M10 x 25
or M10 x 20)
Apply silicone
sealant.
Platform thickness Bolt to use
5 mm or under: M10x20
5-10mm: M10x25
over 10 mm: locally supplied bolts
*1
*1:
How to fasten the antenna base to platform
4. Unfasten four screws to open the cover.
Remove and discard the packing material
inside the radome.
Remove and
discard the
packing material.
Snap holder
Antenna unit, inside view
The antenna base is fitted with a snap holder,
which may be used to hang the cover after
removal. Use the hole next to the screw hole
inside the cover to hang it.
a) Unfasten the snap assy. with the string
attached at the holder in the antenna
base.
b) Unwind the string.
c) Attach the snap to the screw hole on the
inside of the cover.
Note: Do not use the snap holder to hang
objects other than the cover.
5. Release the cable of the rotation detector
from the cable clamp.
6. Unfasten 11 screws to dismount the shield
plate.
7. Pass the antenna cable with connector
through the gasket and cable clamp, and
then tighten the cable gland. Two gaskets
are supplied: one gray, one black. Use the
proper gasket according to antenna cable
used, referring to the illustration below.
67
φ
12
Use gray gasket.
49
φ
11
Use black gasket.
Antenna unit, top view
8. Referring to the figure below, fasten the
shield cable with a screw (M4 x 10) on the
chassis to ground the unit.
Connect 9 pin
connector
here (J801).
Connect
shield here.
How to connect the antenna cable
to the antenna unit
9. Attach the EMI core to the antenna cable.
Set the EMI core fixing plate to the EMI
core.
Pass the cable through the plate
so the bend faces downward.
EMI core fixing plate
30


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Furuno 1715 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Furuno 1715 in the language / languages: English as an attachment in your email.

The manual is 1,71 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info