288592
61
Zoom out
Zoom in
Previous page
1/67
Next page
121120
Problem Cause Remedy
Troubleshooting e If you think the camera is faulty, check the following once more
Problem Cause Remedy
No power. • The battery is exhausted.
The AC power adapter plug has come out
of the power outlet.
• The camera is not connected to the cradle
correctly.
• Load a new fully charged battery.
• Plug the adapter back in.
Ensure that the camera is properly fitted
into the cradle.
Power cuts out during
operation.
• The battery is exhausted. • Load a new fully charged battery.
Battery runs out quickly. Camera is being used in extreemely cold
conditions.
• The terminals are soiled.
• The battery is flat.
Put the battery in your pocket or another
warm place to heat it and then load it into
the camera just before you take a picture.
Wipe the battery terminals with a clean,
dry cloth.
• Load a new fully charged battery.
No photograph is taken
when the shutter button
is pressed.
• No SmartMedia is loaded.
• The SmartMedia is fully recorded.
• The SmartMedia is write-protected.
• The SmartMedia is not formatted.
• The SmartMedia contact area is soiled.
• The SmartMedia is damaged.
The Auto Power Save function has
switched the camera off.
• The battery is exhausted.
• Load a SmartMedia.
Load a new SmartMedia or erase a
frame.
• Remove the write-protection.
• Format the SmartMedia.
• Wipe the SmartMedia contact area with a
clean dry cloth.
• Load a new SmartMedia.
• Switch the camera on.
• Load a new fully charged battery.
Can’t use the flash to
take pictures.
The Mode switch and Mode dial has been
moved to another setting.
• The flash is closed.
The Photography mode is which the flash
does not fire was used.
The shutter button was pressed wile the
flash was charging.
• Set the Mode switch and Mode dial to the
correct setting.
• Pop the flash up.
Select a mode in which the flash can be
used. (P.42)
Wait until charging is completed before
pressing the shutter button.
The flash will not charge. • No compatible SmartMedia is loaded.
• The flash is closed.
• The battery is exhausted.
Load a new SmartMedia, erase a frame,
or remove the write-protection.
• Pop the flash up.
• Load a new fully charged battery.
The playback image is
too dark even though I
used the flash.
• The subject is too far away.
• The flash was covered by your finger.
The flash was pressed down with your
finger.
• Move closer to the subject.
• Hold the camera correctly.
• Hold the camera correctly.
The image is blurred. • The lens is dirty.
The lens is zoomed to telephoto in Macro
mode.
• The photographed subject was too dark.
• Clean the lens.
• Cancel Macro mode.
Try standing about 2 m (6.6 ft.) from your
subject to take the picture.
There is speckling on
the image.
The shot was taken with a shutter speed
slower than 1/4 second.
• This is a characteristic of CCDs and does
not indicate a camera fault.
61


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fujifilm finepix4800 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fujifilm finepix4800 in the language / languages: English as an attachment in your email.

The manual is 3,49 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info