510440
32
Zoom out
Zoom in
Previous page
1/73
Next page
62 63
Advanced Photography
3
M MANUAL
EXPOSURE MODES
2
Set the Exposure mode dial to “M”.
h Bulb photography can only be used in Manual
exposure mode.
h A tripod should be used for bulb photography.
3
1 Use the Main-command dial to set the shutter
speed to “ ” and then 2 use the Sub-
command dial to set the aperture setting (minimum
aperture to maximum aperture).
4
Compose picture, focus and shoot.
h The shutter will be open as long as the shutter release button is kept fully depressed.
h Using the cable release (sold separately) or remote release (sold separately) instead of
holding the shutter release button down with your finger reduces camera shake.
02
01
Exposure compensation allows you to intentionally vary the optimum exposure value controlled by
the camera. This can be useful when intentionally achieving under- or overexposure. Use Center-
weighted or Spot metering. Exposure compensation can be performed in any exposure mode
(However in “M” exposure mode, only the electronic analog exposure display changes—selected
shutter speed and aperture do not change).
1
2
Set exposure compensation by rotating the Main-
command dial while pressing the “b” button until
the desired compensation value appears (–3 EV to
+3 EV in 1/2 EV steps).
h When the exposure compensation is set, “
d
appears on the top display panel and viewfinder.
The Electronic analog exposure display also
appears in the viewfinder. The compensation
value can be checked by pressing the “b
button.
h Electronic analog exposure display indicates the
exposure compensation value and “0” blinks.
h Normally, you should compensate exposure to
the + side when the background is brighter than
your main subject, or to the – side when the
background is darker.
h See P.73 for information on using flash exposure
compensation to adjust the amount of light
emitted by the flash.
Compose picture, focus and shoot.
h To cancel exposure compensation, set the compensation amount to “0.0” or perform a Two-
Button Reset (P.109) (Turning the camera off does not cancel exposure compensation).
–0.5 EV compensation
<Electronic analog exposure display>
+2 EV compensation
01
02
Remote Release Compatibility
This camera can be used with 10-pin remote releases.
Use the remote release (sold separately) with a tripod (sold separately) to prevent camera shake.
Connect the remote release to the 10-pin terminal by matching the indicators on the terminal and
accessory cord.
Nikon accessories that can be used with the 10-pin terminal.
i Remote Cord MC-20 i Remote Cord MC-30
i Extension Cord MC-21 i Luminosity Controller Set ML-3
i Remote Cord MC-22 i Conversion Cord MC-25
!
When not using the 10-pin terminal, always fit the terminal cap.
Dust or soiling in the terminal can cause malfunctions.
!
If Auto Power Off has shut down the camera, the camera cannot be started up again from an accessory. (Use the
custom settings to specify the delay until Auto Power Off shuts down the camera.)
!
The Connection Cord MC-23 is not supported.
!
If the camera loses power while you are using a cable release or directly holding down the shutter button, it cannot
save the photographed image. If you are using a 10-pin remote-control cable, the image is saved at the point the
batteries run out of charge.
!
Attach the bundled clamp filter when using the remote release
(Secure the clamp filter by looping the cord through the filter at
the connector end of the cord, as shown in the figure on the
right).
b EXPOSURE COMPENSATION
32


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fujifilm Finepix S3 Pro at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fujifilm Finepix S3 Pro in the language / languages: English as an attachment in your email.

The manual is 6,29 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info