Manual Fujifilm finepix s 2 pro (page 58 of 65) (English)

288584

Zoom out

Zoom in

1/65

115114

—

i Switch the camera off and replace the lithium

batteries. Then switch the camera back on

and try again.

If this does not resolve the problem, set the

focusing mode to “M”, release the shutter and

briefly switch the camera off.

i The lithium batteries are low on

charge or the camera mechanism

has stopped due to cold and

cannot take pictures.

(blinking)

Warning Displayed

Top display panel

View finder

Explanation Remedy

i Switch the camera off, close the slot cover,

switch the camera back on and try again.

i Switch the camera off and replace the AA-

size batteries or load new AA-size batteries.

Then switch the camera back on and try

again.

—

i Release shutter again. If the warning

indication remains, or this warning appears

frequently, contact you FUJIFILM dealer.

i Malfunction detected.

(blinking)

i The slot cover was opened during

card operation.

i The AA-size batteries are low on

charge or flat.

i No AA-size batteries are loaded.

(lit)

(blinking)

Warning Displays

eThe table below lists the warning messages displayed on the

top display panel or in the viewfinder.

Warning Displayed

Top display panel

View finder

Explanation Remedy

i CPU Nikkor lens other than G-type

is not set to its minimum aperture.

i Attached flash is not set at TTL

Auto Flash in “P” mode.

i Set lens to minimum aperture.

i Set the external flash mode to TTL, or set the

camera’s exposure mode to “S”, “A” or “M”.

(blinking)

i Lithium Batteries are low on charge. i Have new ones ready.

—

i Lithium Batteries have no remaining

charge.

i Turn the power off and replace lithium

batteries with new ones.

i Attach CPU lens (except IX-Nikkor). With a

non-CPU lens, set the exposure mode to “M”

and set the aperture with lens’ aperture ring.

—

i Non-CPU lens is attached or lens is

not attached.

(blinking)

i Focus manually.i Autofocus is not possible.

—

(blinking)

i In “P” mode, use ND filtre (If the warning

indication remains after performing above

remedies in “S” or “A” mode, use ND filtre as

well).

i In “S” mode, select faster shutter speed.

i In “A” mode, select smaller aperture (larger f-

number).

i Overexposure warning (subject is

too bright).

(lit)

i In “P” mode, use flash (If the warning

indication remains after performing above

remedies in “S” or “A” mode, use flash as

well).

i In “S” mode, select slower shutter speed.

i In “A” mode, select larger aperture (smaller f-

number).

i Underexposure warning (subject is

too dark.).

(lit)

i When the subject is too bright, use ND filtre

and when the subject is too dark, use flash

too the electronic analog exposure display

remains blinking when the flash is used.

i Subject brightness is beyond

camera’s exposure range.

—

Electronic

analog

exposure

display

(blinking)

i Release the shutter as it is to take a flash

picture (Shutter speed automatically shifts to

1/125 sec.).

i Shutter speed faster than sync

speed is selected in “S” or “M”

mode.

Shutter speed

indication

(blinking)

(lit)

i Cancel the “™” or select “M” mode.i Shutter speed is set to “™” in

“S” mode.

(blinking)

i Shoot again after confirming focus distance,

aperture or flash shooting distance range.

i Flash has fired at full output and

underexposure may have occurred.

—

(blinking)

In certain cases, due to static electricity or poorly loaded batteries, the FinePix S2 Pro

microcomputer may turn the camera off, even with fresh, properly installed batteries. For the same

reason, the operation of camera may not advance properly during either “USB mode” or “IEEE1394

mode”. In each of these cases, to resume operation, simply turn the power off, then turn it on

again. Or, remove and reinstall the batteries.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Fujifilm finepix s 2 pro in the language / languages: English as an attachment in your email.

The manual is 4,93 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Fujifilm finepix s 2 pro Manual

Product: