39
Installation
The Fuave ACS09K01 is a portable air conditioner/humidier that can be
moved from room to room.
• Remove the packaging material, keep it out of children’s reach and
make sure that the appliance remains standing upright.
• Before use, check whether all the accessories are present and whether
the appliance and the accessories do not show any damage. Do not
start using a damaged appliance, but return it to your supplier!
• Place the appliance on a rm, even, dry and horizontal surface close to
a socket and drainage possibility for warm air, for example, by a window
that can be slightly opened. Make sure that the appliance has at least
50 cm free space on all sides and observe all the directions stated in the
safety instructions.
• To dehumidify, connect a water drain hose to the connection point for
the water drain hose (10). Lead this hose into a bucket or pit. The hose
must not be routed upwards! Your appliance can now be used (see
section on water drainage).
• To cool, you have to discharge the warm air to the outside.
• Avoid bends or curves in the drain hose. This causes a built-up of
exhausted humid air, which can result in leakage, overheating or
switching off the airco.
• Warning! Do not use your airco before you have followed all the
installation instructions described above!
• Warning! Make sure that no water enters the interior of the appliance!
• Warning! The length of the drain pipe has been adapted specically
to the technology of this airco. Do not replace or extend it using your
own hose. This could have an adverse effect on the functioning of your
airco. The hose can be extended, but the length should be as short as
possible for optimal effect.
• Do remember to prevent break-in! After all, the window is open
when using the portable air-conditioner.