Manual Frilass 76059 (page 19 of 33) (English, German, Dutch, French)

621646

Zoom out

Zoom in

1/33

5.0 SOME POSSIBLE PROBLEMS

1. Burning through thin metal. On very thin sheet eg-car bodywork, even the

lowest amperage setting will be too fierce. In this case you can still use your

welder but you will need a brazing kit which is available from your stockist.

2. Machine cuts out frequently.

This is probably caused by a sticking electrode.

Even one sticking electrode could cause the machine to cut out for up ten

minutes. After this time it should be ready to use again.

3. Difficulty in striking an arc

can be experienced if the electrode is damp. Heat

it up to 60

-70

before using.

4. Difficulty in striking an arc

can be experienced if you use the wrong type of

rod. Only ACID or RUTILE electrode can be used with these machines.

BASIC electrodes are unsuitable for these machines.

6.0 VARIOUS WELDING SYSTEMS

1. For metal up to 7 mm thick,

keep pieces 2-3 mm apart.

A second run can go under-

neath for extra strenght.

See illustration.

2. For thicknesses up to 30

mm a single butt joint is

necessary, filling up the

space with several layers

of weld.

See illustration.

3. Over 30 mm you will need

a double "V" butt joint

and again fill up the

space.

See illustration.

7.0 GRAPHICAL SYMBOLS

ELECTRODE HOLDER

Use only electrodes as stated in

chapter 4.0.

EARTH CLAMP

This must be clamped to the work-

piece. The machine will not work

unless in contact with bare metal.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Frilass 76059 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 1,63 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Frilass 76059 Manual

Product: