590299
8
Zoom out
Zoom in
Previous page
1/36
Next page
8
Control locations of the gas surface burners
Your range is equipped with gas surface burners with
different BTU ratings. The ability to heat food quicker and in
larger volumes increases as the burner size increases.
The small simmer burner is best used for simmering
delicate sauces, etc. This burner is located at the right rear
burner position on the cooktop. The standard burner can be
used for most surface cooking needs. The standard burners
are located at the left front and left rear positions on the
cooktop.
The power burners are best used for bringing large quanti-
ties of liquid rapidly up to temperature or when preparing
larger quantities of food. The power burner is located at the
right front position on the cooktop. Regardless of size,
always select cookware that is suitable for the amount and
type of food being prepared. Select a burner and flame size
appropriate to the pan. Never allow flames to extend
beyond the outer edge of the pan.
Assembly of the surface burner caps and burner
grates
It is very important to make sure that all of the surface
burner caps and surface burner grates are installed
correctly and at the correct locations.
1. Remove all packing material from cooktop area.
2. Discard all packing material (if applicable).
3. Unpack burner grates and position on the cooktop.
The word REAR is stamped on the back of the burner
grates to help assure that the proper end of the grates
are placed to the rear of the cooktop.
The grates are designed to rest inside the recess on
the cooktop.
To install burner grates, place grates flat-side down
and align into the cooktop recess.
Grates should rest flush against each other and
against the sides of the recess.
IMPORTANT
Figure 1: Proper grate installation
Do not allow spills, food, cleaning agents or any other
material to enter the gas orifice holder opening.
Always keep the burner caps and burner heads in place
whenever the surface burners are in use.
Burner cap lip
Burner cap
Burner head
IMPORTANT
Correct burner cap
placement
Incorrect burner cap
placement
BEFORE SETTING SURFACE CONTROLS
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Frigidaire FPGH3077RF at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Frigidaire FPGH3077RF in the language / languages: English as an attachment in your email.

The manual is 15,3 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info