613170

Friedland SA5 Manual

24
Zoom out
Zoom in
Previous page
1/52
Next page
INSTALLATION
22 SA5
DEFAULT SETTINGS
User Setup
Users 1-6: Not programmed
Master User Access Code: 1234
System Setup
House Code: Not programmed
Alarm Time: ON, 180s
Wirefree Siren: ON
RF Jamming Detection: OFF
Back Light: 10s
Alarm Relay: On Until Disarm
Zone Lockout: ON
Remote Phone Control: OFF
Rings to Answer Phone: 6
Dial Delay: ON
Dial method: Tone/DTMF
Dialler Mode: Voice Dialler
Zone Setup (Z1-10)
Name: No Name
Type: Intruder
Final Exit: OFF
Chime: OFF
Entry Delay Zone 1: ON, 30s
Zones 2-10: OFF
Part-Arm 1 Zones 1-4: ON
Zones 5-10: OFF
Part-Arm 2: OFF
Walk Through: OFF
Voice Dialler Setup
Phone Numbers: Not programmed
Message Play Time: 70s
Alarm Messages: Not programmed
Call Routing: All numbers disabled
Call Confirms: 1
Call Attempts: 3
Full Arm Setup
Exit Delay: ON, 30s
Entry Delay Beep: ON
Exit Delay Beep: ON
Part-Arm 1 Setup
Exit Delay: ON, 30s
Entry Delay Beep: ON
Exit Delay Beep: ON
Part-Arm 2 Setup
Exit Delay: ON, 30s
Entry Delay Beep: ON
Exit Delay Beep: ON
Time & Date
Time: 12:00:00
Date: 01/01/02
Latchkey Setup
Status: OFF
Selected User Setup: OFF (all users)
Phone Numbers: Not programmed
Answer Phone Setup
Status: OFF
Greeting Message: Not programmed
Remote Manager Setup
Phone No: Not programmed
Unit ID No: Not programmed
Call Attempts: 3
RESET FACTORY DEFAULT
CONDITIONS
1
.Press
, ,
This puts the system into Test Mode.
2
. Undo the Control Panel cover fixing screws and
open the cover.
3
.Remove the DC power jack, then remove and
disconnect one of the back-up batteries.
4
. Set jumper link P1 to the ON position.
5
. Reconnect the power supply jack.
6
. The Control Panel will now reconfigure itself with
all factory default settings.
‘EEPROM RESET’ will be displayed while the
defaults are restored to memory. Once the memory
reset has been completed ‘DISARM READY’ will
be displayed.
7
. Reconnect and replace the back-up battery.
8
. Reset jumper link P1 into the OFF position.
9
. Close the Control Panel cover and refit the fixing
screws.
? ? ? ?
ENTER
User Access Code
OFF ON
Jumper
Link P1
… 24 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Friedland SA5 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Friedland SA5 in the language / languages: English as an attachment in your email.

The manual is 0,4 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info