720138
20
Zoom out
Zoom in
Previous page
1/112
Next page
20
Insert the capsule as shown in the picture.
Lower the movable part of the top of the machine completely,
and press the lever “A until you hear it lock in place.
Position the cup on the cup stand “H”.
Start
Press (one button only):
- the
button to brew an espresso coffee.
- the
button to brew a long espresso.
When the coffee has reached the programmed level in the cup,
brewing will stop automatically.
Note: The pre-programmed volume for each button has
been set with the aim of satisfying the majority of users.
The brew setting for each button can be adjusted accor-
ding to personal taste by following the instructions in the
paragraph below.
Warning:
The capsules are single-dose and cannot be used to make
two coffees.
Remember to clean the drip tray “I” and empty the used
capsule container “G”.
Remember to change the water in the tank frequently.
ADJUSTING THE QUANTITY OF
COFFEE IN THE CUP
The machine allows you to set the desired quantity/volume of
coffee in a cup for both brew buttons and .
Note: for the sake of simplicity, we will illustrate only how to
program the espresso button
; to program the long coffee
button you must carry out the same steps, but press the
latter button and use a suitably sized mug.
To adjust and program a personalized quantity of coffee to
be brewed, proceed as follows:
- Insert a capsule in the compartment “B”.
- Place an espresso sized cup on the cup stand ”H”.
- Touch the espresso button
and keep it pressed
until reaching the desired quantity of coffee. Then release
the button. The machine is now programmed; the next time
you press the espresso button the machine will brew
the quantity you have just programmed.
The programming replaces the factory settings.
MANUAL STOP
You can stop brewing coffee before the automatic stop by
again pressing the button you just selected.
Warning: in any case brewing will stop automatically after
a preset maximum time of about 70 seconds. In this case,
coffee could overfl ow from the cup.
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Francisfrancis Y 1.1 Touch at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Francisfrancis Y 1.1 Touch in the language / languages: English, German, Dutch, Danish, French, Italian, Spanish as an attachment in your email.

The manual is 5,2 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info