628407
9
Zoom out
Zoom in
Previous page
1/48
Next page
9
Keys
S500
RESET key: press this key for a few seconds to reboot the microproces-
sor of the control unit after a block and/or an anomaly.
This operation DOES NOT cancel the programming and system settings
S501
DEFAULT key: Press the “Default” and “Reset” keys simultaneously to re-
store the factory settings and cancel all the settings of the control unit.
For performing the default procedure, follow the procedure described in
paragraph 9
S1
TAMPER key can be pressed from the control unit cover. If the cover is
removed during normal operations, a tampering alarm is generated
Connectors
J200
Connector for the connection to MOD-USB, which is used to carry out
Firmware updates of the control unit.
J800
J801
These 2 connectors are necessary to install and connect the speech card
(optional)
For the speech card installation,
refer to the card manual
VOCAL-416
5.2 Description of the terminal boards
J1 terminal board
Terminal Features
+13,8 Positive from the feeder – 13.8Vcc
GND Negative from the feeder – 0Vcc
J3 terminal board
Terminal Features
L4 Sensor connection of line 4
L3 Sensor connection of line 3
+B Feeding point no. 1 – power supply to the input devices 12Vcc 500mA max
GND Ground – negative of the feeding point and sensor reference
L2 Sensor connection of line 2
L1 Sensor connection of line 1
OUT5 Open collector output, which can be programmed. Negative in the event
of activation. Max 50mA
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fracarro CE2N-416 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fracarro CE2N-416 in the language / languages: English as an attachment in your email.

The manual is 4,6 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info