779802
20
Zoom out
Zoom in
Previous page
1/28
Next page
EN
CUTTING OPERATION
WARNING:
AFTER ANY KIND OF ADJUSTMENT, A SHEAR TEST IS RECOMMENDED.
a. If necessary, adjust workbench angle.
b. Place the rip fence according to the cut you need.
c. Place and block the upper blade guide 3 mm over the workpiece.
Note: Before cutting the workpiece, make a shear test, and if necessary correct the adjustment.
a. Place the workpiece on the workbench.
b. Connect the plug.
c. Switch on the bandsaw.
d. Begin to cut one piece at a time. Always guide the workpiece with both hands by keeping it against the
workbench, in order to avoid that the saw blade get stuck. Move the piece forward using a pressure level
which must be constant and just sufficient for the blade to cut the workpiece without getting stuck.
e. Switch off the machine if you don't need to use it immediately, and disconnect it.
WARNING:
ALWAYS USE THE PUSH-STICK IF YOU CUT SMALL WORKPIECE. PUSH-STICK (28)
FIG.16 MUST ALWAYS BE AT HAND AND FIXED TO THE HANGER (29) FIG.16 DESIGNED
FOR THIS AIM.
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fox F28-182A at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fox F28-182A in the language / languages: English as an attachment in your email.

The manual is 1.35 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info