733021
199
Zoom out
Zoom in
Previous page
1/264
Next page
197
EN
Source: Shimano
®
techdocs
Get thorough instructions from your
FLYER specialist dealer and practise
changing the wheels and tyres under
their supervision if you plan to repair
your own at tyres. The system must be
switched off and the battery must be re
-
moved before changing a tyre or wheel.
You need the following equipment to repair a tire
puncture:
Plastic tire lever
Patches
Rubber cement
Sandpaper
Open-ended spanner or wrench (for wheels
without quick release skewers)
Air pump
Spare tube
Your FLYER is equipped with a disc brake. This
way, you can remove the wheel without doing any
further preparation.
Please note: when tting the wheel, the disk must
be slotted between the brake linings of the brake
calliper and ultimately be centred without contact.
1. Removing the wheel
If your FLYER is equipped with a quick-release
lever or a thru axel, open them.
If your bike has hexagonal bolts, then loosen
them in anti-clockwise direction with a tting
ring spanner or box-end wrench.
You can then remove the front wheel according to
the steps listed above.
The following ap
-
plies for rear
wheels:
If your FLYER
uses a derailleur
gear system, change gear to the smallest
sprocket. In this position, the rear derailleur
poses the least hindrance in removing the
wheel.
If your FLYER is equipped with a quick-release
lever or a thru axel, open them.
If your FLYER has hex nuts, loosen these with
a suitable spanner anti-clockwise.
Pull the rear derailleur backwards somewhat.
Lift the bike slightly.
Lightly strike the wheel from above with the
palm of the hand.
Take the wheel out of the frame.
Types of valve on bicycle tubes
2. Removing the tyre and inner tube
Unscrew the valve cap, the fastening nut and
possibly the cap nut from the valve.
Release all of the remaining air from the inner
tube.
Insert the tyre lever opposite the valve on the
inside of the tyre.
Insert the second tyre lever approx. 10 cm from
the rst, between the rim and tyre. Lift the tyre
bead over the edge of the rim.
Repeat this lifting action around the wheel until
the entire tyre is free.
Remove the inner tube from the tyre.
3. Change the inner tube
Switch the inner tube for an intact one.
Tubular tires and tubeless tires must be
changed according to the tires and rims’
manufacturers instructions.
4. Reassembling the tyre and inner tube
Please avoid allowing foreign bodies in-
side the tyre. Ensure that the inner tube
does not have any folds and is not
squashed.
Ensure that the rim tape covers all spoke
nipples and does not have any damage.
Sclaverand
199


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Flyer Mountain - Bosch 2019 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Flyer Mountain - Bosch 2019 in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 7,2 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info