624063
8
Zoom out
Zoom in
Previous page
1/16
Next page
4
TS22 Series Craft Test Sets
Users Guide
Figure 2. Line Cords
Switchable Electronic Ringer
With the amplified monitor speaker on, the audible
warble is enabled. The amplified speaker can be used
to hear incoming ringing, as the amplified speaker
amplifies any audio receive signal in either the TALK or
MONITOR mode.
TS22A DataSafe™ Feature
TheTS22A Test Set is designed to Bellcore Technical
Reference TR-TSY-000344. The high impedance
monitor allows connection in Monitor mode to DSO
and DS1 data circuits without disturbing transmission.
Voice Controls
Figure 3 describes the voice controls for the TS22 Series
Test Set.
TS22 Amplified Speaker
The TS22 Test Set has an amplified speaker that
amplifies the received signal in TALK or MONITOR
mode. This lets you listen to the test set without
holding it to your ear.
The SPEAKER button controls the volume of the
amplified speaker. The speaker has three volume levels
(low, medium, and high).
Note
When the speaker is on, the polarity LEDs go
out. They will turn back on when the speaker
timer elapses or is turned off via the SPEAKER
button.
When the speaker is on, the transmitter and receiver
are automatically switched off to prevent acoustic
feedback. With no signal present, the speaker will
automatically turn off after 5 minutes to conserve
battery power. Any signal greater than a nominal
-30 dBm will reset the timer and keep the speaker
turned on.
bfs02.eps
Standard Line Cord (STD) with Piercing Pin Clips: This cord consists of one red and one black conductor, each
approximately five feet long. Each conductor has an alligator clip offset 20° to minimize clip shorting. The
clips have insulation piercing spikes and a neoprene boot.
Angled Bed-of-Nails Cord (ABN): The Angled Bed-of-Nails cord is similar to the STD cord, except that
each alligator clip is equipped with a “bed-of nails” in addition to the insulation piercing spike.
Central Office Plug Cord (SR): This one-foot cord has a type 346A female plug. The plug allows the use of a
variety of different test cords equipped with the matching 471A male connector.
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fluke networks TS22 Series at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fluke networks TS22 Series in the language / languages: English as an attachment in your email.

The manual is 0,28 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info