624063

Fluke networks TS22 Series Manual

14
Zoom out
Zoom in
Previous page
1/16
Next page
10
TS22 Series Craft Test Sets
Users Guide
Note
Be sure to replace the battery with a good 9 V
battery or the test set will not operate at all.
To replace the battery (see Figure 5):
1
Disconnect the test set from the line and place on
a flat work surface with battery cover up.
2
Using a Phillips screwdriver, remove the three
screws from the battery compartment.
3
Remove the battery compartment cover.
4
Lift out the battery retainer.
5
Remove the old battery from the battery boot.
6
Insert a new alkaline 9 V battery.
7
Replace the battery boot, retainer, cover, and
screws. Strain relief ring must be inside the case as
shown. Avoid pinching battery wires.
bfs06.eps
Figure 5. Battery Replacement
Replacing the Belt Clip
See Figure 6.
The belt clip assembly is field replaceable in the event
of damage or prolonged wear. To order a replacement
belt clip, contact your local Fluke Networks authorized
distributor.
To replace the belt clip assembly:
1
Using a Phillips screwdriver, remove the two screws
that secure the belt clip to the test set housing.
2
Remove the old belt clip and replace with a new
one. Secure the belt clip assembly to the test set
housing with the original screws.
bfs07.eps
Figure 6. Belt Clip Replacement
… 14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fluke networks TS22 Series at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fluke networks TS22 Series in the language / languages: English as an attachment in your email.

The manual is 0,28 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info