775815
15
Zoom out
Zoom in
Previous page
1/21
Next page
Validating Ethernet Service
11
Validating Ethernet Service
The toner detects link pulses for 10BASE-T, 100BASE-TX,
and 1000BASE-T Ethernet service on pins 1, 2 and 3, 6 of its
RJ45 jack.
1
Turn off the toner.
2
Connect the toner to the circuit as shown in Figure 3.
3
Turn the toner’s rotary switch to SERVICE.
4
The Ethernet LED indicates service on pins 1, 2 or 3, 6
as shown in Figure 3.
The toner checks for continuity between pins 4, 5.
Continuity indicates the toner is connected to a network
device that is turned off.
The toner checks for continuity between the red and black
test leads and across the middle pair of the RJ45/RJ11 jack
(line 1).
Note
If the Ethernet LED alternates between red and
green, the Ethernet service is Auto-MDIX.
ASH01.EPS
Figure 3. Validating Ethernet Service
Punch-down
block RJ45
RJ11
SERVICE
Red:
service on 1, 2
Continuity or
non-Ethernet
voltage
No voltage
No continuity
Green:
service on 3, 6
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fluke networks IntelliTone Pro 200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fluke networks IntelliTone Pro 200 in the language / languages: English as an attachment in your email.

The manual is 0.72 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Fluke networks IntelliTone Pro 200

Fluke networks IntelliTone Pro 200 Quick start guide - English, German, French, Spanish - 2 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info