775815

Fluke networks IntelliTone Pro 200 Manual

12
Zoom out
Zoom in
Previous page
1/21
Next page
IntelliTone Pro 200 LAN
Users Manual
8
Validating RJ11 and RJ45 Cable Maps
You can use the IT200 toner and IP200 probe to validate
the cable map on RJ11 and RJ45 connectors. The cable
map function finds the most common wiring faults on
twisted pair cabling: shorts, opens, and crossed pairs.
1
Connect an IT200 toner to a RJ11 or RJ45 jack, as
shown in Figure 2.
2
Turn the toner’s rotary switch to .
3
If necessary, use the IP200 probe to locate the correct
connector at the other end of the cabling, as
described in the previous section.
4
Connect the IP200 probe to the RJ11 or RJ45 jack;
then turn the probe’s rotary switch to CABLE MAP.
5
The probe’s LEDs and beeper indicate the cable map,
as follows:
The number of each LED corresponds to a pin on
the connector. You can enable the SYNC LED to
validate the shield. See “Validating the Cable’s
Shield” on page 10.
Each LED that corresponding to an active pin
flashes briefly, then should light for about 1
second. The brief flash shows which LED is next in
the sequence.
The probe also beeps in different tones to indicate
good wiring, miswires, shorts, and opens.
Miswire: If one LED flashes briefly, then another
LED lights for one second, the wire for the first
LED is miswired to the pin for the second LED.
Short: If two LEDs turn on for 1 second at the same
time, those two pins are shorted together. If more
than 2 wires are shorted together, the LEDs for the
shorted pins indicate opens.
Open: If an LED flashes briefly, then no LEDs turn
on, that pin is open.
… 12 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fluke networks IntelliTone Pro 200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fluke networks IntelliTone Pro 200 in the language / languages: English as an attachment in your email.

The manual is 0.72 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Fluke networks IntelliTone Pro 200

Fluke networks IntelliTone Pro 200 Quick start guide - English, German, French, Spanish - 2 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info