763940
70
Zoom out
Zoom in
Previous page
1/100
Next page
8808A
Users Manual
4-10
Note
In external trigger mode (mode 2 to mode 5), *TRG command is always
available.
Setting the Trigger Type Configuration
To set the trigger type configuration using the computer interface, enter the command
TRIGGER <type> (where <type> is the trigger type) and press Enter. See Table 4-3 for
trigger types.
Select trigger type 3 or 5 to enable the settling delay if the input signal is not stable before
a measurement is triggered. Typical settling delays are provided in Table 4-3. RS-232
reading transfer rates are provided in Table 4-4.
Table 4-4. RS-232 Reading Transfer Rates
Readings per Second
Rate
Internal Trigger Operation (Trigger 1) External Trigger Operation (Trigger 4)
Slow 2.5[1] 2.5[2]
Medium 20[1] 20[2]
Fast 100[1] 100[2]
[1] Depends on A/D trigger speed.
[2] Depends on how fast the trigger signal is transmitted.
External Trigger via the Computer Interface
To trigger a measurement using the RS-232 computer interface, enter the command
*TRG and press Enter. See the “Common Commands” section later in this chapter for use
of *TRG command.
To trigger a measurement using pin 9 of the RS-232 interface, see Figure 4-1.
+5 V Out (Pin 1)
Trig In (Pin 9)
eue24.eps
Figure 4-1. External Trigger Using Pin 9 of RS-232 Interface
70


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fluke 8808A at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fluke 8808A in the language / languages: English as an attachment in your email.

The manual is 1,96 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Fluke 8808A

Fluke 8808A User Manual - German - 102 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info