764336
86
Zoom out
Zoom in
Previous page
1/130
Next page
753/754
Users Manual
74
In the results summary test, failures are highlighted. An
adjustment is necessary in this example because three
tests show failures. The failures were outside the
±0.5 % tolerance that was selected.
20. Push the Done softkey to keep the data, or the Abort
softkey to erase the data and start again.
See the data entry that was recorded and recall the
table later with the Review Memory softkey during
normal operation. This data can be uploaded to a host
computer that runs compatible DPCTrack2 application
software. See “Communication with a PC”.
Transmitter Adjustment
Note
Always read the transmitter manufacturer’s
instructions to find the adjustment controls and
connection points for your transmitter.
To make calibration adjustments to the transmitter:
1. Push the Done softkey after you review the results
summary.
2. Push the Adjust softkey. The Product sources 0 % of
span (100 °C in this example) and shows these
softkeys:
Go to 100%/Go to 0%
Go to 50%
As Left
Done
3. Adjust the transmitter output for 4 mA and then push
the Go to 100% softkey.
4. Adjust the transmitter output for 20 mA. If HART
adjustments (output Trim and Sensor trim) are
necessary, please refer to the 754 HART Mode Users
Guide.
5. If the span was adjusted in step 4, do steps 3 and 4
until adjustment is no longer necessary.
6. Examine the transmitter at 50 %. If it is in specification,
the adjustment is done. If not, adjust the linearity and
start this procedure again at step 3.
86


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fluke 754 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fluke 754 in the language / languages: English as an attachment in your email.

The manual is 5,57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Fluke 754

Fluke 754 User Manual - German - 130 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info