764336
76
Zoom out
Zoom in
Previous page
1/130
Next page
753/754
Users Manual
64
To ramp (for example, sweep the source):
1. See the applicable section earlier in this manual (for
example, “Source Electrical Parameters”) and
connect the Product to the test circuit.
2. To automatically stop the Ramp function if a trip
condition is sensed, connect a voltage trip circuit to
the V MEASURE jacks or a continuity trip circuit to
the mA Ω RTD MEASURE jacks. (Continuity
detection is not available when sourcing current.)
3. If necessary, push for SOURCE mode.
4. Set the Product for the necessary source value as
given before.
5. To Ramp the output in % of scale, set % of scale as
given before under “Measurement Scale”.
6. Push the More Choices softkey.
7. Push the Ramp softkey. The display changes to the
screen shown Figure 25.
8. Record the parameters given. Record the Start
Value, End Value, and Ramp Time.
9. To automatically stop the Ramp function if a trip
condition is sensed, set the Trip Detect to Enabled,
and select Voltage or Continuity as the trip function.
gks41s.bmp
Figure 25. Ramp Screen
10. Push the Done softkey. Note RAMP next to
SOURCE at the top of the display.
11. Select a low-to-high ramp or a high-to-low ramp with
the Ramp Up/Down softkey.
12. To start the Ramp function, push the Start Ramp
softkey.
13. The Ramp function continues until a trip is sensed (if
enabled), the ramp time expires, or the Stop Ramp
softkey is pushed. See Figure 26.
76


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fluke 754 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fluke 754 in the language / languages: English as an attachment in your email.

The manual is 5,57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Fluke 754

Fluke 754 User Manual - German - 130 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info