764336

Fluke 754 Manual

56
Zoom out
Zoom in
Previous page
1/130
Next page
753/754
Users Manual
44
Measure or Source with Custom Units
Warning
To avoid possible electric shock, when using
Custom Units for measurement, always see the
secondary value displayed below and to the
right of the main display for the actual value of
the measurement in native engineering units.
The measurement or source display can be setup to show
custom units. To do this, select a function, for example mV
dc, scale it as necessary, then record an alphanumeric
name for the custom units, for example, “PH.”
To set up a custom unit:
1. When you measure or source the necessary function,
push the Scale softkey, and then select Custom Units
from the list.
2. Record the 0% and 100% scale points for the input of
the transfer function.
3. Push the Custom Units softkey.
4. Record the 0% and 100% scale points for the output of
the transfer function.
5. Record the name of the custom units (up to four
characters), for example PH (for pH), using the
alphanumeric entry window, then push .
While Custom Units are active, shows on the display to
the right of the custom unit. Once the custom measurement
unit has been programmed, the unit is available for
calibration procedures in split-screen MEASURE/SOURCE
mode. To cancel Custom Units, push the Custom Units
softkey again.
Using the 700-IV Current Shunt
To source and measure current simultaneously, a current
shunt is necessary and uses the volts measure function.
The Fluke 700-IV Current Shunt is designed specifically for
use with the 700 Series Documenting Process Products.
To measure current with the current shunt:
1. Connect the current shunt to the MEASURE V jacks.
2. Connect the current signal to be measured to the
current shunt.
3. Push to select the dc voltage measure function.
4. Push the Scale softkey.
5. Select Current Shunt from the list.
6. Push .
7. The Product is automatically configured and uses the
correct custom scaling factor for the current shunt.
… 56 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fluke 754 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fluke 754 in the language / languages: English as an attachment in your email.

The manual is 5,57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Fluke 754

Fluke 754 User Manual - German - 130 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info