Manual Fluke 190-102-III (page 39 of 98) (English)

775826

Zoom out

Zoom in

1/98

ScopeMeter® Test Tool

Recorder Functions

Turn Off the TrendPlot Display

Push 4 to exit the recorder function.

Recording Scope Waveforms In Deep Memory (Scope Record)

The SCOPE RECORD function is a roll mode that logs a long waveform of each active input. This

function can be used to monitor waveforms like motion control signals or the power-on event of

an Uninterruptable Power Supply (UPS). During recording, fast transients are captured. Because

of the deep memory, recording can be done for more than one day. This function is similar to the

roll mode in many DSOs but has deeper memory and better functionality.

Starting a Scope Record Function

To record, for example, the input A and input B waveform:

1. Apply a signal to input A and input B.

2. Press Q to open the RECORDER main menu.

3. Use the cursor and E to highlight Scope Record and start the recording.

The waveform moves across the screen from right to left like on a normal chart recorder. See

Figure 18.

Figure 18. Recording Waveforms

Observe that the screen shows:

• Time from start at the top of the screen.

• The status at the bottom of the screen that includes the time/div setting as well as the total

timespan that fits the memory.

Note

For accurate recordings allow the test tool to warm up for a minimum of five minutes. For

long recordings, make sure the power supply is connected.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Fluke 190-102-III in the language / languages: English as an attachment in your email.

The manual is 9.23 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Fluke 190-102-III Manual

Product: