775836
28
Zoom out
Zoom in
Previous page
1/62
Next page
1773/1775/1777
Users Manual
22
Note
Make sure IPv6 is enabled on your Windows system.
Ethernet
Use a commercially available Cat 5 or higher Ethernet patch cable to connect the Analyzer to
your LAN (local area network). A communication over Ethernet requires that each device has a
unique IP address. Two options exist: Either a device obtains an address from a DHCP server
or the device uses a static, user-configured address.
The default setting of the Analyzer is to obtain an IP address from a DHCP server automatically.
The Analyzer allows a Ethernet point-to-point connection between the Analyzer and a PC. The
Analyzer has Auto-MDI-X support to switch automatically between 1:1 for a device-to-LAN
connection and cross-over mode required for a device-to-device connection. A cross-over
cable is not required. The Analyzer and PC self-assign IP addresses in the range of 169.254.x.x
automatically after the timeout to receive an IP address from a DHCP server expires.
Note
During the typical timeout of 1 minute, Windows shows the status “Identifying” in the
network status. Windows may show an exclamation mark in the network status icon
indicating that the connection does not provide Internet access. This is normal.
The Analyzer communicates with the Fluke Energy Analyze Plus software on these ports:
The software installer for Energy Analyze Plus automatically adds exceptions to the Windows
firewall. If a third party firewall is used, add the ports and the application fea.exe to the
exception list.
Type Port Number
TCP 80 (HTTTP)
TCP 443 (HTTPS)
TCP 18571
UDP 18572
28


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fluke 1777 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fluke 1777 in the language / languages: English as an attachment in your email.

The manual is 3.36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info