576523
61
Zoom out
Zoom in
Previous page
1/76
Next page
61
GB
Fitting the saw chain
G
1. Switch the saw off and unplug it
from the mains.
2. Spread the chain (5) out into a
loop with the cutting edges run-
ning clockwise .
3. Slide the saw chain (5) into the
bar guide groove. To mount the
guide bar (4), raise it to an angle
of approx. 45 degrees. This will
make it easier to replace the saw
chain (5) onto the sprocket (23).
It is normal that the saw chain (5)
is slack. Sagging in the chain is
normal.
4. Pre-tighten the chain (5) by turn-
ing the tensioning plate (22)
clockwise.
5. Position the sprocket chain wheel
covering (15). First place the tab
(24) on the cover into the corre-
sponding notch on the plate (15).
Only lightly tighten the fastening
bolt (14), as you will still have to
tension the saw.
Refer to the start-up section on how
to tension the saw chain.
Sawing techniques
General
You have better control when you saw
with the bottom side of the chain bar
(with pulling saw chain) and not to with
the top side of the chain bar (with push-
ing saw chain).
The saw chain must not contact either
the ground or another object during
sawing through or after sawing comple-
tion.
Make sure that the saw chain does not
become jammed in the wood. Do not
let the tree trunk break or split off.
Consider also the precautions against
spring-back (see notes on safety).







Bucking
This refers to sawing up a felled tree trunk
into smaller sections.
Ensure that the saw chain does not
come in contact with the ground during
sawing.
Make sure you have a secure stance
and, in the case of sloping ground,
stand above the log.
K
 
Saw through the log completely
from above and ensure at the
end of the cut not to contact the
ground.
If you can turn the tree trunk, saw
two-thirds of the way through it.
Then turn the trunk around and
saw the rest of the way through
from above.
L
 

Start sawing from the bottom and
work your way up (with the up-
per edge of the bar) a third of the
way into the diameter of the trunk
to prevent splitting. Then saw from
the top downwards with the lower
61


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Florabest FKS 2200 B1 - IAN 72314 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Florabest FKS 2200 B1 - IAN 72314 in the language / languages: English, German, Dutch as an attachment in your email.

The manual is 4,2 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info