648104

Fisher and Paykel WashSmart Manual

7
Zoom out
Zoom in
Previous page
1/44
Next page
5
Installation instructions
If you have an uncontrolled water heating source (eg a wet back or solar heating system) you
should fit a Hot ‘N’ Safe Valve. This will ensure the hot water temperature remains within safe limits.
Hot ‘N’ Safe Valves available are:
RMC TVA 50HF
RMC TVA 75HFS
Adjustable between 35°C – 55°C
RMC TVA 50HP
For instantaneous gas hot water supply
Water supply requirements:
Inlet water pressure: Maximum 1 MPa (150 psi), Minimum 30 kPa (4.5 psi)
Inlet water flow rate: Minimum 6 litres / minute
Cold supply only:
If you only have a cold water supply, the inlet valve cap (blanking cap) which came with your
washer must be connected to the hot inlet valve. The cap prevents water leaking out of the hot
valve. This appliance incorporates backflow protection complying with AS3500.1. No further
backflow protection is required for connection to the water supply.
Note: your washer has an internal heater to heat water. If you do not connect a hot water inlet
hose, your washer will automatically recognise there is no hot water supply and its internal
heater will heat the cold water to the required cycle temperature.
Draining
Drain hose placement
1
To guide the drain hose over the tub or standpipe
the hose guide must be fitted to the drain hose.
The height of the standpipe or tub should be
between 800 – 1200mm.
2
Secure the hose guide so it cannot become
dislodged from the standpipe or tub.
Important!
If the drain hose is placed on the ground or if the
standpipe or tub is less than 800 mm high, the
washing machine will continuously drain while
being filled (siphon).
Regularly check that your standpipe or tub is free from lint or other obstructions, which may
affect how your machine works or may cause flooding.
The drain hoses should be checked from time to time and replaced if any damage (eg wear, cuts,
bulges, kinks, leaks, etc) is found. Do not bend the drain hose sharply, as this may cause it to split.
In multi-storey apartments or any upper floor, the machine should be installed on a floor
equipped with a drain.
Draining must comply with local by-laws.
Fig.5 Fitting the drain hose guide
(20 mm)
maximum
Standpipe 800 – 1200 mm
Pull hose
through
guide
… 7 …


Need help? Post your question in this forum.

Forumrules
1

Forum

fisher-and-paykel-washsmart

Reset search

  • Message reads “too full”. It is not too full but removed some items message still the same. Anything I can do or time to buy new one. It’s about 8 years old. And over the last 15 months had a lot of use as extra 3 people in household. Submitted on 1-3-2022 at 22:21

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fisher and Paykel WashSmart at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fisher and Paykel WashSmart in the language / languages: English as an attachment in your email.

The manual is 5,84 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info