671466
8
Zoom out
Zoom in
Previous page
1/27
Next page
8
Assembly Instructions and
Towards Front of Rower
Rear Brace
Bungee Hook Mount
Pre-installed Bolt
STEP 1
Rear Brace Assembly and Left/Right Side Rails
a) Start with the Rear Brace and on the underside you will
find a Pre-installed bolt. From the hardware kit, take
the Bungee Hook Mount and install it onto the Rear
Brace as shown. Note the orientation of the Brace and
hook must be correct in order to hold the end of the
Bungee Shock Cord as depicted by the arrow in the
illustration, which points toward the front of rower.
2
b) Next, connect the Side Rail Left and Side Rail Right[2]
using 4x M6x15mm Bolts[10] and Rear Brace[5].
DO NOT TIGHTEN.
Tip: Bumpstops facing inside of rail for correct assembly
orientation.
c) Once the Rear Brace and Side Rails are assembled,
mount the Transport Wheel Assembly[8] onto the
Left/Right Side Rails[2].
Note: One washer on outside and one washer on the
inside of the side rail.
REQUIRED
Side Rail Left / Right [2]
Rear Brace [5]
Bungee Hook Mount [7]
Transport Wheel Assembly [8]
4x M6x15mm Bolts [10]
WARNING
Rotate Rear Brace to correct
orientation before assembly
onto Side Rails
WARNING
Note Transport wheels must
be mounted on the outside of
Side Rails As shown on the
right.
Do not over tighten the
Transport Wheel Axle as it
may inhibit Transport Wheel
rotation.
Side Rail Right
Side Rail Left
Rear Brace
M6x15mm Bolts
Bumpstop
M8 x 60mm Bolt
Transport Wheel
M8 Washer
M8 Washer
Transport Wheel Assembly
M8 Nylock Nut
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for First Degree VIKING 2 AR at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of First Degree VIKING 2 AR in the language / languages: English as an attachment in your email.

The manual is 2,36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info