671439
29
Zoom out
Zoom in
Previous page
1/32
Next page
29
Replacing the Rower Bungee Shock Cord
6. Move the Rowing Handle from the
S-Bend to a point where it is resting
on top of the tank . This helps line
up the Bungee Cord hole for easier
removal/replacement. Detach Bungee
Cord from lower rear attachment
point.
5. After removing the Magnetic Ring
and the C-Clip, the Bungee Cord will
be accessible. Remove the Belt/Bungee
Pulley off the shaft, pull the Bungee
Cord through the Belt/Bungee Pulley
and remove. Thread new Bungee Cord
through and pull until knotted end is
held securely in the slot.
Caution: Do not loosen the Belt.
Re-Wrapping
7. Lower left front to upper left front
Pulley.
Hint: Keep a slight tension on the
Bungee Cord when threading through
the Bungee Pulleys.
8. Upper left front to lower middle left
and right Pulleys.
Remove
Replace
C Clip
9. Middle right Pulley to upper right Pul-
ley.
29


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for First Degree E316 Fluid Rower at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of First Degree E316 Fluid Rower in the language / languages: English as an attachment in your email.

The manual is 2,9 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info