795123
13
Zoom out
Zoom in
Previous page
1/28
Next page
13
Regular Maintenance
This unit has been designed to be as maintenance-free as possible, but there are a few simple things you
must do to keep it working properly:
Test it at least once a week.
Clean the Smoke/CO Alarm at least once a month; gently vacuum the outside of the Smoke/CO
Alarm using your household vacuum’s soft brush attachment. A can of clean compressed air (sold at
computer or oce supply stores) may also be used. Follow manufacturer instructions for use. Test
the Smoke/CO Alarm. Never use water, cleaners or solvents since they may damage the unit.
If the Smoke/CO Alarm becomes contaminated by excessive dirt, dust and/or grime, and
cannot be cleaned to avoid unwanted alarms, replace the unit immediately.
Relocate the unit if it sounds frequent unwanted alarms. See “Where This Alarm Should Not Be Installed” for details.
When the battery becomes weak, the Smoke/CO alarm will “chirp” approximately once a minute (the low
battery warning). This low battery warning should last for up to 7 days, but you should replace the battery
immediately to continue your protection.
!
IMPORTANT: Actual battery service life depends on the Smoke/CO Alarm and the environment
in which it is installed. Regardless of the manufacturer’s suggested battery life, you MUST
replace the battery immediately once the unit starts “chirping” (the “low battery warning”).
Replacement Batteries
Your Smoke/CO alarm requires a 3 cell lithium metal battery. You can purchase your replacement batteries
at www.firstalertstore.com.
WARNING: Always use the exact batteries specified by this User’s manual. DO NOT use
rechargeable batteries. Install batteries correctly with regard to polarity ( + and -).
Please dispose of or recycle used batteries properly, following any local regulations. Consult your
local waste management authority or recycling organization to find an electronics recycling facility
in your area. DO NOT DISPOSE OF BATTERIES IN FIRE. BATTERIES MAY EXPLODE OR LEAK.
Keep battery out of reach of children. In the event a battery is swallowed, immediately contact your poison
control center, your physician, or the
National Battery Ingestion hotline at 202-
625-3333 as serious injury may occur.
To Replace Batteries
It is recommended that you remove the Smoke/CO Alarm
from the mounting bracket before replacing the batteries.
Step 1 Slide open the battery compartment.
Step 2 Pull out the battery, squeeze release lever
on connector and pull to release battery.
1
Release
Lever
2
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for First Alert OneLink - 1042136 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of First Alert OneLink - 1042136 in the language / languages: English as an attachment in your email.

The manual is 1.25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info