795123

First Alert OneLink - 1042136 Manual

11
Zoom out
Zoom in
Previous page
1/28
Next page
11
When the Alarm Sounds (Continued)
What To Do If The CO Alarm Sounds
1. Press the Test/Silence button (On App or on unit).
2. Call your emergency services, fire department or 911.
3. Immediately move to fresh air—outdoors or by an open door or window. Do a head count to check that all persons
are accounted for. Do not re-enter the premises, or move away from the open door or window until the emergency
services responder has arrived, the premises have been aired out, and your CO Alarm remains in its normal condition.
4. After following steps 1-3, if your CO Alarm reactivates within a 24-hour period, repeat steps 1-3 and call a qualified
appliance technician to investigate for sources of CO from fuel-burning equipment and appliances, and inspect for
proper operation of this equipment. If problems are identified during this inspection have the equipment serviced
immediately. Note any combustion equipment not inspected by the technician, and consult the manufacturers’
instructions, or contact the manufacturers directly, for more information about CO safety and this equipment. Make
sure that motor vehicles are not, and have not, been operating in an attached garage or adjacent to the residence.
NOTE: A qualified appliance technician is defined as “a person, firm, corporation, or company that either in person or through a
representative, is engaged in and responsible for the installation, testing, servicing, or replacement of heating, ventilation, air conditioning
(HVAC) equipment, combustion appliances and equipment, and/or gas fireplaces or other decorative combustion equipment.”
!
WARNING: Actuation of this device indicates the presence of carbon monoxide (CO) which can KILL YOU.
If alarm signal sounds (description of alarm signal, eg four beeps): (1) immediately move to fresh air outdoors or by
an open window. check that all persons are accounted for. Do not reenter the premise or move away from the open
door/window until the emergency service responders have arrived, the premises have been aired out, and your alarm
remains in its normal condition; (2) call you emergency local service (telephone number) (fire department or 911)
(ii) If “service” signal sounds (description of the trouble signal eg. one beep)
Using the Silence Feature
The Silence Feature
This feature is intended to temporarily silence the horn while you identify and correct the problem. Do not
use the Silence Feature in emergency situations. It will not correct a CO problem or extinguish a fire. The
Silence Feature can temporarily quiet an unwanted alarm for several minutes. You can silence this Smoke/
CO Alarm by pressing the Test/Silence button on the alarm cover for at least 3-5 seconds or via the
Onelink app. After the Test/Silence button is released, the Red LED stops during the silence mode.
Silence the End of Life Signal
This silence feature can temporarily quiet the End of Life warning “chirp” for up to 2 days. You can silence the End of
Life warning “chirp” by pressing the Test/Silence button or via the Onelink app. The horn will chirp, acknowledging
that the End of Life silence feature has been activated. After approximately 2 days, the End of Life “chirp” will resume.
!
WARNING: Never deactivate the unit to quiet an unwanted alarm.
Deactivating the alarm disables the unit and removes your protection.
… 11 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for First Alert OneLink - 1042136 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of First Alert OneLink - 1042136 in the language / languages: English as an attachment in your email.

The manual is 1.25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info