779788

Ferrex SLM531 Manual

29
Zoom out
Zoom in
Previous page
1/48
Next page
AFTER SALES SUPPORT
(toll free)
224cc 4 Stroke Petrol Lawn Mower
e-mail: info.aldi@positecgroup.com1300 889 028
MODEL No.: SLM531 • 09/2021 • 10093
27
6. Again remove the oil ller cap/dipstick (19) and check the oil level. It should
be at the top of the full (H marking) indicator on the dipstick (19). (Fig. H3)
7. If low, add oil slowly into the engine oil ll. Do not overll. After adding
oil, wait one minute and then recheck the oil level.
8. Re-position and tighten the oil ller cap/dipstick (19). Always ensure the oil
ller cap/dipstick (19) is rmly locked in place before the engine is started.
NOTE: Do not allow engine to run low on oil as it will reduce the life of the
engine.
NOTE: Do not over ll with oil above the full indicator mark.
Fuelling
IMPORTANT: Fuel goes o after about 3-4 months. If you nd your
lawn mower does not start, rst change the fuel in the tank (28)
with newly purchased fresh unleaded fuel. Do not use ethanol based fuels.
WARNING. Do not rell fuel tank (28) while engine is running or is
hot.
• Be careful not to admit dust, dirt, water or other foreign objects into
the fuel.
• Wipe o spilt fuel thoroughly before starting engine.
• Ensure you DO NOT fuel the lawn mower in close proximity to any
open ames, lit cigarettes, or hot objects.
1. Unscrew the fuel tank cap (27) and pour fresh unleaded fuel into the tank
(28) with the aid of a funnel. (Fig. I1-I3 )
2. Fill the tank (28) to approximately 2.5 cm below the lowest portion of the
neck to allow for fuel expansion. Be careful not to over ll or spill any fuel.
If this happens, wipe the spill with a clean rag.
3. Start the engine at least 3 metres away from the area where the fuel tank
(28) has been lled in order to avoid the risk of re.
Preparing for Operation
I3I1 I2
… 29 …


Need help? Post your question in this forum.

Forumrules
1

Forum

ferrex-slm531

Reset search

  • Hi,WHAT PART NUMBER IS THE DRIVE SELF PROPELLED BELT FOR THIS FERREX SLM531.WHAT IS THE BEST WAY TO REPLACE BELT?
    THANK YOU
    REGARDS STEPHEN Submitted on 3-2-2025 at 07:55

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ferrex SLM531 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ferrex SLM531 in the language / languages: English as an attachment in your email.

The manual is 2.77 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info