724613
28
Zoom out
Zoom in
Previous page
1/48
Next page
224cc 4 Stroke Petrol Lawn Mower
AFTER SALES SUPPORT
e-mail: info.aldi@positecgroup.com
1300 889 028
MODEL No.: SLM530 • 08/2019 • 10093
(toll free)
26
2. Remove the oil ller cap / dipstick (24) by turning
approximately a quarter turn in an anti clockwise
direction and lift the cap outwards. Clean the
oil ller cap / dipstick (24) with a clean cloth,
cleaning away any visual oil (Fig W).
3. FOR A NEW LAWN MOWER, add 500ml of
4 stroke SAE 10W/30 engine oil.
4. Insert the oil dipstick back and secure the oil ller
cap / dipstick (24) by turning approximately a
quarter turn in a clockwise direction.
5. Again remove the oil ller cap / dipstick (24) and
check the oil level. It should be at the top of the
full (H marking) indicator on the dipstick (Fig X).
6. If low, add oil slowly into the engine oil ll.
Do not overll. After adding oil, wait one minute
and then recheck the oil level.
7. Replace and tighten the oil ller cap / dipstick
(24). Always ensure the oil ller cap / dipstick is
rmly locked in place before the engine is started.
NOTE: Do not allow engine to run low on oil as it will reduce the life of
the engine.
NOTE: Do not over ll with oil above the full indicator mark.
Fuelling
IMPORTANT: Fuel goes o after about 3-4 months. If you nd your lawn
mower does not start, rst change the fuel in the tank with newly purchased
fresh unleaded fuel. Do not use ethanol based fuels.
WARNING. Do not rell fuel tank while engine is running or is hot.
Be careful not to admit dust, dirt, water or other foreign objects into the fuel.
Wipe o spilt fuel thoroughly before starting engine.
Ensure you DO NOT fuel the lawn mower in close proximity to any open
ames, lit cigarettes, or hot objects.
1. Unscrew the fuel tank cap (26) and pour fresh unleaded fuel into the tank
with the aid of a funnel. (Fig Y )
2. Fill the tank to approximately 2.5 cm below
the lowest portion of the neck to allow for fuel
expansion. Be careful not to over ll or spill any
fuel. If this happens, wipe the spill with a
clean rag.
3. Start the engine at least 3 metres away from the
area where the fuel tank has been lled in order
to avoid the risk of re.
W.
Y.
Preparing for Operation
X.
L (LOW)
H (HIGH)
28


Need help? Post your question in this forum.

Forumrules
1

Forum

ferrex-slm530

Reset search

  • I am trying to replace belt on self propelled mower! can anyone tell me how to do this?

    Thannkyou Submitted on 5-6-2022 at 07:54

    Reply Report abuse
  • self drive inoperative with motor running and lever fully engaged Submitted on 25-12-2021 at 01:52

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ferrex SLM530 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ferrex SLM530 in the language / languages: English as an attachment in your email.

The manual is 10,15 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info