724613

Ferrex SLM530 Manual

27
Zoom out
Zoom in
Previous page
1/48
Next page
AFTER SALES SUPPORT
(toll free)
224cc 4 Stroke Petrol Lawn Mower
e-mail: info.aldi@positecgroup.com1300 889 028
MODEL No.: SLM530 • 08/2019 • 10093
25
Preparing for Operation
Mulch and Mowing
Using the mower without the hard catcher (43) attached, the lawn mower will
mulch as it cuts and and the ne grass clippings are distributed back onto the
grass surface without leaving piles of grass clippings.
WARNING:
Ensure the engine is NOT operating when undertaking this task.
1. Remove the hard catcher (43) by lifting the rear discharge guard and releasing
the hard catcher (43). (Fig T)
2. Lift the rear discharge guard (16), insert the mulching block (39) into
position, then release and close the rear discharge guard (16). (The
mulching block (39) is correctly in place when the circle tabs on the block
click into place at the bottom of the rear discharge chute (Fig U)).
3. Ensure the side ejector cover (21) is in the closed position (Fig V).
Do NOT use the side discharge chute (20) when mulch and mowing.
Adding and Checking the oil
IMPORTANT: The engine of this lawn mower is packed with NO OIL in the
engine. Prior to starting the engine, Oil MUST be added to the sump of
the engine.
Failure to add sucient oil will result in damage to the engine which is
NOT covered under the warranty of the lawn mower.
On a new lawn mower, the engine needs to be lled with 500ml of SAE 10W/30
engine oil. We recommend Ferrex® Full Synthetic 4 Stroke Oil.
Each time the lawn mower is used, the oil level should be checked and if low,
add sucient oil to ensure the oil level is to the full mark on the dipstick.
1. Position the lawn mower on a at and level surface. Clean the area
directly around the oil ller cap / dipstick (24).
V.U.T.
Preparing for Operation
… 27 …


Need help? Post your question in this forum.

Forumrules
1

Forum

ferrex-slm530

Reset search

  • I am trying to replace belt on self propelled mower! can anyone tell me how to do this?

    Thannkyou Submitted on 5-6-2022 at 07:54

    Reply Report abuse

  • self drive inoperative with motor running and lever fully engaged Submitted on 25-12-2021 at 01:52

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ferrex SLM530 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ferrex SLM530 in the language / languages: English as an attachment in your email.

The manual is 10,15 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info