724590
27
Zoom out
Zoom in
Previous page
1/40
Next page
25
Digital Inverter Generator with Pure Sine Wave
AFTER SALES SUPPORT
e-mail: info.aldi@positecgroup.com 1300 889 028
MODEL: №. XG-KF2000 • 03/2020 • 700069 (toll free)
AFTER SALES SUPPORT
(toll free)
e-mail: info.aldi@positecgroup.com1300 889 028
Digital Inverter Generator with Pure Sine Wave
MODEL: №. XG-KF2000 • 03/2020 • 700069
2. Allow the engine to slow down and idle for approximately 15-30 seconds.
Remove any appliances connected to either of the 2 AC sockets.
3. Press the engine On/O switch (2) to the “OFF” position as indicated by an
“O” (Fig. U). The unit will stop running and is shut down.
Now follow the normal starting procedure to restart the generator.
Emergency Stop, and / or failure of On/o Switches (NOT
RECOMMENDED EXCEPT IN EMERGENCY)
In the case of an emergency that requires the
generator to be shut down as fast as possible:
1. Turn “OFF” the 240Va.c Outlet Power On/O
switch (1). If the switches have failed and power is
still going to the appliance outlets quickly move
to step 2.
2. Press the engine On/O switch (2) to the “OFF”
position as indicated by an “O” (Fig. U). The unit
should stop running. If the switches have not shut
down the generator, you can quickly remove / pull out the plugs of the
appliances plugged into the AC sockets (9) that need to be shut down.
3. Where the engine keeps operating, don’t panic, turn the fuel lever / tap
(23) clockwise to the “OFF” position (Fig. T). The generator will run out of
fuel within one minute and then stop.
Do not use the generator again until the generator is serviced by an
authorised service agent and the product is repaired, checked and the fault
corrected.
As always in an emergency protect people that could be in harms way rst.
Carbon build up
Carbon build up can be a problem on generators as the loading on the engine
can vary considerably. Running the generator at low loading for extended
periods can cause carbon build up.
Carbon build up in the engine can be reduced by operating the generator
at approximately 75% of rated load for 25% of the time the generator is
used. i.e, if the generator is used for 4 hours on low load i.e 800W or less, run
the generator for 1 hour at around 75% of rating. This is only required if the
generator has been used for less than 25% of rated load for extended periods.
i.e 2 hrs or more.
NOTE: For best operation and long engine life use unleaded fuel without
ethanol.
U.
27


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ferrex KF2000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ferrex KF2000 in the language / languages: English as an attachment in your email.

The manual is 3,51 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info