724590
19
Zoom out
Zoom in
Previous page
1/40
Next page
17
Digital Inverter Generator with Pure Sine Wave
AFTER SALES SUPPORT
e-mail: info.aldi@positecgroup.com 1300 889 028
MODEL: №. XG-KF2000 • 03/2020 • 700069 (toll free)
AFTER SALES SUPPORT
(toll free)
e-mail: info.aldi@positecgroup.com1300 889 028
Digital Inverter Generator with Pure Sine Wave
MODEL: №. XG-KF2000 • 03/2020 • 700069
3. Power Supply indicator (Fig C)
The power supply indicator light (6) is a green LED. It will only display
green when there is a 240V output available, thus the generator must be
operating.
This indicator will remain on when the
generator is operating and has 240Va.c.
available to the control panel, with or
without appliances connected to the
AC sockets (9). In an overload condition,
there is no 240Va.c. available to the
panel so the green indicator will not
operate.
Preparing the Generator
It is important to check the generator before you commence operating the
unit.
IMPORTANT. Ensure that the engine has oil. When leaving the factory, this
generator has NO OIL in the engine.
NOTE. The engine will not start if the generator has no oil.
Checking the Engine Fuel
IMPORTANT: Fuel goes o after about 3-4 months. If you nd your generator
does not start, rst change the fuel in the tank with newly purchased fresh
unleaded fuel. Do not use ethanol based fuels.
IMPORTANT: If replacing old fuel from the generator ensure to drain the old
fuel from the carburettor bowl until the new fuel drains from the bowl. Drain
the bowl via the fuel drain screw (10).
WARNING!
Do not rell fuel tank (26) while engine is running or is hot.
Check to ensure that the fuel drain screw (10) has been tightened and
that fuel is not leaking.
Be careful not to admit dust, dirt, water or other foreign objects into the
fuel.
Wipe o spilt fuel thoroughly before starting engine.
Ensure you DO NOT fuel the generator in close proximity to any open
ames, lit cigarettes, or hot objects.
C.
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ferrex KF2000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ferrex KF2000 in the language / languages: English as an attachment in your email.

The manual is 3,51 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info