734919
22
Zoom out
Zoom in
Previous page
1/30
Next page
Operation
22
In doing so, only apply light pressure to the saw blade.
Cover the cutting line with a suitable coolant when cutting metal.
Make sure to pay attention to the maximum material thickness to be machined:
Wood: 80 mm
Plastic: 12 mm
Metal: 5 mm
Sawing out sections
Use a drill to bore a 10 mm hole in the section to be sawn out. Insert the saw
blade
15
into this hole and begin to saw out the desired section.
Performing plunge cuts
Plunge cutting is necessary if it the starting position is not located on the edge of a
work piece or if no hole has been drilled in advance. If a hole is drilled in advance,
it must be large enough to carry the saw blade. In this case, you can proceed as
described in the chapter section “Sawing”.
Proceed as follows for a plunge cut:
1. Switch the product on (see chapter ‘Switching product on and off’)
2. Place the product on the saw shoe’s rounded front edge
7
.
3. Slowly lower the saw blade until it touches the workpiece.
4. Slowly let the saw blade
15
cut into the workpiece, without applying pressure.
5. As soon as the saw blade comes out on the other side of the workpiece, switch the
product off (see chapter ‘Switching the product on and off’).
6. Lift the product and, at the same time, carefully pull the saw blade out.
7. Insert the saw blade in the cut you just made, but this time with the product in the
normal position (the saw shoe is securely resting on the workpiece and is in full
contact with it).
8. Switch the product on and continue cutting.
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ferrex FAPS 20-I at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ferrex FAPS 20-I in the language / languages: English as an attachment in your email.

The manual is 1,61 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Ferrex FAPS 20-I

Ferrex FAPS 20-I User Manual - German - 32 pages

Ferrex FAPS 20-I User Manual - French, Italian - 88 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info