510124

Ferm SSM1005 Manual

7
Zoom out
Zoom in
Previous page
1/68
Next page
Ferm 7
EN
Mains connection
Only use earthed sockets with earthing wire connected per the regulations.
Replacing the mains connection cable
The mains connection cable may only be replaced by a special cable in a specialised workshop.
Replacing cables or plugs
Dispose of old cables or plugs immediately after replacing them. It is dangerous to connect the plug of a
loose cable to a wall socket.
Using extension cables
Only use an approved extension cable, corresponding to the machine power use. The wires must have
a minimum cross section of 1.5 mm
2
. If the cable is on a reel, it must be fully paid out.
3. INSTALLING ACCESSORIES
Always disconnect the machine from the main power supply before carrying out any
maintenance work
Installing the protective cover
Fig.B
• Beforecommissioningthemachine,theprotectivecover(5)mustbeinstalled.
• Insertthescrewfromtheinsideleft,thenaffixthewasherandthesafetyringfromtherightside.The
safety ring (A) may be left out optionally.
• Screwtheknurlednutintight.
Installing the cross guide
Fig.C
The cross guide (3) allows material to be bevelled, and can be simultaneously used to support the
material as it is fed through the saw.
Mounting the rubber feet
Fig. G
The enclosed rubber feet contribute to a steady position of the scroll saw on your worktable
• Placetherubberfootonitsplace
• Connecttherubberfootwithhelpoftheenclosedbolt,ringandnut
• Tightenthenutwithawrench
Sawdust blower
Fig. H
The sawdust blower keeps the workpiece clean for more accurate scroll cuts. For best results, always
direct air flow from the blower tube at blade and workpiece. To adjust, simply bend to desired position.
Installation
• Placethesawdustblowerontheholeontopofthemachine
• Turntheblowpipeclockwiseintothehole
… 7 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ferm SSM1005 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ferm SSM1005 in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 2,16 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info