632706

Ferm LBM1008 - FLB 2500 Manual

4
Zoom out
Zoom in
Previous page
1/24
Next page
DK
Ferm
45
• Do not use power tools in the rain or wet
environments.
• We strongly recommend the use of an RCD
(Residual Current Device) of not more than 30
mA, at the plug socket when using this
appliance.
• Do not use power tools where there is a risk
of fire or explosion - i.e. near flammable
liquids or gases.
• Do not allow people especially children or
pets into the area where you are working.
• Do not let children or other people touch
power tools.
• Store in a dry place well out of reach of
children.
• Always use safety glasses. We also
recommend the use of ear protectors.
• Wear the right clothes (long trousers) - not
loose fitting or jewellery and ensure garments
cannot come into contact with moving parts.
• Wear non-slip shoes. Do not wear sandals or
open-toed shoes.
• If you have long hair, tie it back safely to avoid
tangling it in moving parts.
• Before using any power tool, check first for
damaged parts and if found do not use them
before the part or parts have been replaced
with new ones.
• Do not use power tools when you are tired or
have been drinking alcohol.
• Do not overreach while working - you may
lose your balance.
• You must switch off your tool at the tool’s
on/off switch after use.
• Only use this appliance for its intended
purpose - blowing or sucking up leaves.
• Do not point the blower at people or animals.
• Do not blow debris in the direction of people
or animals.
• Operate the appliance only in daylight or in a
good artificial light.
• Do not place your hand inside the blower tube
or bag until the blower has been switched off
and the plug removed from the power supply.
• Only use extension leads that are suitable for
outdoor use. The cord must be kept away
from excessive heat, oil, solvents and sharp
edges.
• Do not use the vacuum to remove liquids of
any kind.
• Do not vacuum up hot or burning materials
i.e. fire embers, matches, recently
extinguished cigarette stubs.
• Never operate the vacuum without the bag
securely fitted.
• Periodically check that all bolts and screws
are tight.
• The operator or user is responsible for
accidents or hazards occurring to other
people or their property.
• To prevent dust irritation we recommend the
wearing of a face mask.
• Always direct the cable to the rear away from
the appliance.
• Do not carry the appliance by the cable.
• Disconnect the appliance from the mains
supply
• Before clearing a blockage.
• Before checking, cleaning or maintaining
the appliance.
• If the appliance starts to vibrate
abnormally.
• Whenever you leave the machine.
• Always be sure of your footing on slopes.
• Walk, never run.
• Keep all cooling air inlets clear of debris or
obstructions.
• Keep all nuts, bolts and screws tight to be
sure the appliance is in safe working
condition.
• Check the debris collector frequently for
wear or deterioration.
• Replace worn or damaged parts.
• Use only genuine replacement parts and
accessories.
Immediately switch off the machine when:
• Excessive sparking of the carbon brushes and
verticiliosis in the collector.
• Interruption of the mains plug, mains lead or
mains lead damage.
• Defect switch
• Smoke or stench of scorched isolation
Electrical safety
When using electric machines always observe
the safety regulations applicable in your country
to reduce the risk of fire, electric shock and
personal injury
. Read the following safety
instructions and also the enclosed safety
instructions.
Always check that the power supply
corresponds to the voltage on the rating
plate.
GB
04
Ferm
… 4 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ferm LBM1008 - FLB 2500 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ferm LBM1008 - FLB 2500 in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 0,42 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info