46 Ferm
STAPLE- AND NAIL MACHINE
THE NUMBERS IN THE FOLLOWING TEXT COR-
RESPOND WITH THE PICTURES AT PAGE 2
TECHNICAL SPECIFICATIONS
PACKAGE CONTENTS
• tacker
•400 staples
•100 nails
• manual
•guarantee card
SAFETY INSTRUCTIONS
The following symbols are used in these instructions for
use:
Denotes risk of personal injury, loss of life or
damage to the tool in case of non-observance of the
instructions in this manual.
Denotes risk of electric shock.
Carefully read this manual before using the machine.
Make sure that you know how the machine functions and
how to operate it. Maintain the machine in accordance
with the instructions to make sure it functions properly.
Keep this manual and the enclosed documentation with
the machine.
ELECTRICAL SAFETY
Warning! When using electric tools, basic safety pre-
cautions should always be followed to reduce the
risk of fire, electric shock and personal injury. Read
all these instructions before attempting to operate
this product and save these instructions.
Always check that the mains voltage corresponds
to the voltage on the rating plate.
The machine is double insulated in accordance with
EN50144; therefore no earth wire is required.
Replacing cables or plugs
Immediately throw away old cables or plugs when they
have been replaced by new ones. It is dangerous to insert
the plug of a loose cable in the wall outlet.
Using extension cables
Only use an approved extension cable suitable for the
power input of the machine. The minimum conductor
size is 1.5 mm2. When using a cable reel always unwind
the reel completely.
SPECIFIC SAFETY INSTRUCTIONS
Before using the tacker
1. Check the following points:
•Do the voltage of the engine and the engine safe-
guard, if any, correspond to the mains voltage
(appliances for a mains voltage of 230 V);
•Are the mains lead and the mains plug in a good
condition: solid, without any loose ends or
damage.
2. Always wear eye protection when using the tool.
3. Maintain the tool with care.
4. Check for misalignment or binding of moving parts,
breakage of parts, and any other condition that may
affect the tools operation. If damaged, have the tool
serviced before using.
5. Check if the slide cartridge has been fastened pro-
perly.
6. Do not use the tool in a humid environment.
7. Do not use the tool on materials containing asbestos.
Using the tool
1. Do not use the tool if the switch does not turn it
"ON" or "OFF".
2. Always hold the tool with two hands while starting.
3. Always keep the cord away from the moving parts of
the machine.
4. Keep your hands away from the work piece.
5. In the case of jamming by a nail or staple, switch the
machine off immediately and remove the plug from
the mains.
6. Never aim the tool at people or animals.
7. Use only staples or nails fit for this tool.
8. Make sure not to damage any leads when using the
tool.
Voltage | 230 V~
Frequency | 50 Hz
Number of staples | 20/min.
Max. staple depth | 14 mm
Weight | ca. 0.9 kg
