Installation of batteries
Remove the cover of the battery compartment on the rear panel of
the remote control unit; slide it downwards and put it aside. Insert
two AAA (R03) batteries into the compartment, observing the
indicated polarity. Do not mix old and new batteries, or
batteries of different types. Replace the battery compartment
cover. Slide it upwards until it locks in place.
Note
:
•
If the LED’s become dim; please replace the
batteries.
To make your remote control ready for use, you need to carry out one of the
following steps:
Set up device via auto search
1. Switch on the device that you like to control.
2. Point the remote control at your device. Press and hold down the device
button (e.g. TV) for 5 seconds. The LED turns on and after a moment LED
start flashing, that means RCU660 is in auto search mode and you can
release device button.
3. The “Volume+” signal is automatically transmitted from the remote control to
the device (code scan). As soon as the volume of the device (e.g. TV)
changes, immediately press device button to stop the auto search.
If the device you are searching for is a CD player, Tuner, TAPE, or AUX then
“Power” (instead of “Volume+”) signal is automatically transmitted from the
remote control to the device. As soon as the device turns off, press device
key to stop the search. You need to turn on the device by Power button
before you check other button function.
4. Check the function of the other buttons on the remote control. If none of the
buttons function (i.e. the search was not be stopped in time) or the majority
of the buttons do not function correctly, restart the search (see steps 2 to 4)
to find a suitable code. If the majority of the buttons function correctly, set-
up has been successful. Re-press the device button (e.g. TV) to save the
code and to terminate the set-up mode.
Note:
• Entering the auto searching mode, it will search forward from the current
code.
• Sometimes, remote control does not work properly just because auto search
was not stopped in time. In this case, just enter into manual search again,
and press Vol– button approx. every 1.5 seconds to search backward the
code database.
• If you are not satisfied with certain buttons assignments, or some functions
are missing, then you can use additionally learning function.
9
