Setup device via brand name code
1. Switch on the device that you like to control.
2. Find the code number of your device brand in the code list (e.g. Ferguson
1244) from the relevant device group (e.g. DVB-T).
3. Press and hold the device button (e.g. AUX) for three seconds. Release the
device button as soon as LED lights up, now it is in set up mode.
4. Enter the 4-digit device code (e.g. 1244 for Ferguson DVB-T) within 10
seconds. If an entry is not made within 10 seconds, the set- up mode is
automatically terminated.
5. The LED turns off if the remote accepts the code. If the LED flashes three
times, that means the code may be wrong, and the remote control remains in
set-up mode, enter the correct code from the list again in good time.
6. Check the function of the buttons on remote control. If it does not function
correctly, try another 4-digit device code from the list under the same brand.
Repeat steps 3 to 6 until all the basic functions operate correctly.
7. Exit the set-up mode by pressing the device button.
Note:
• If you are not satisfied with certain buttons assignments, or some functions
are missing, then you can use additionally learning function.
• mode is automatically terminated if no button is pressed for 10 seconds.
Setup device via manual search
1. Switch on the device that you like to control.
2. Point the remote control at the device. Press and hold down the device
button (e.g. TV) for 5 seconds. The LED lights up and the remote is in manual
set-up mode, release the device button now.
3. Press the Vol+ button approx. every 1.5 seconds.
4. As soon as the volume of the device (e.g. TV) changes or the device turns off,
check whether the other buttons on the remote control function correctly. If
the majority of the buttons does not function correctly, press the Vol+
approx. every 1.5 seconds to initiate the reactive code (manual search is
continued, see steps 3 to 4).
5. If the majority of the buttons on the remote control functions correctly, save
the code by pressing the device button (e.g. TV) to terminate the manual
search.
Note:
• If you are not satisfied with certain buttons assignments, or some functions
are missing, then you can use additionally learning function.
• Sometimes, remote control does not work properly just because manual
search was not stopped in time. In this case, just enter into manual search
again, and press Vol– button approx. every 1.5 seconds to search backward
the code database.
•
The Manual Search is automatically terminated if no entry occurs during 30
seconds period.
•
Manual search mode, search forward from the current code.
10
