784931
15
Zoom out
Zoom in
Previous page
1/24
Next page
For further inquiries, please contact our Customer Service Team
Email: ahsservice@watkinsmfg.com Phone: +1 760 598 6464 12
CONTROL PANEL OPERATION
DIAGNOSTIC LCD MESSAGE
Message Meaning Action Required
No message on display.
Power has been cut off to the spa.
The control panel will be disabled until power
returns. Spa settings will be preserved until
next power up.
HL The system has shut the heater
off because the temperature at the
heater has reached 50°C (122°F).
Do not enter the water!
DO NOT ENTER THE WATER. Remove the
spa cover and allow the water to cool down,
then shut power off and power your spa up
again to reset the system.
If spa does not reset, shut off the power to the
spa and contact your local Dealer.
AOH Temperature inside the equipment
compartment is too high 90°C
(194°F), causing the internal
temperature in the control system to
increase above normal limits.
Open equipment compartment and wait until
error clears.
PRR A problem is detected with the
temperature probe.
Call your Dealer or service supplier.
OH The water temperature in the spa
has reached 42°C (108°F). Do not
enter the water!
Remove the spa cover and allow the water to
cool down to a lower temperature. Call your
dealer or service supplier if problem persists.
UPL No low level configuration software
has been installed into the system.
Call your Dealer or service supplier.
FLO No water flow is detected by the
control system but flow is expected.
Make sure that the jet pump is running and
water is flowing; check and clean filters; make
sure water valves are open; make sure spa
has a proper water level. If problem persists,
call your Dealer or service supplier.
Smart Winter Mode will
automatically go on when a risk of
freezing occurs.
No action is required, it will automatically go off
when the treat of freezing is no longer there.
See previous page for more information.
WARNING! SHOCK HAZARD! NO USER
SERVICEABLE PARTS.
Do not attempt service of the control box. Contact
your local Dealer for assistance. Follow all owner
manual power connection instructions. Installation
must be performed by a licensed electrician and all
grounding connections must be properly installed.
WARNING! DO NOT ENTER SPA IF WATER
IS TOO HOT
Water is too hot. Overheat protection heater
is deactivated. Spa water temperature is above
acceptable limits. When the actual water
temperature is approximately 1º C (2º F) above
the set temperature, the jet pump will stop
operating to reduce (frictional) heating. If the spa
water temperature continues to rise and gets
above 42ºC (108º F), the spa will go into an “OH”
overheat condition.
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fantasy Splendor at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fantasy Splendor in the language / languages: English as an attachment in your email.

The manual is 0.7 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info