500344

Falcon Toledo XT 110 Manual

46
Zoom out
Zoom in
Previous page
1/60
Next page
46
INSTALLATION
Check the ap pli ance is electrically safe and gas sound when you have fi nished.
Make sure you lower BOTH REAR ROLLERS. There are two
adjusting nuts, one for each roller, at both the front bottom
corners of the cooker.
Unfold the rear edge of pack base tray. Carefully push the
cooker backwards into position. Take care not to damage
the power cable. Push the cooker close to its fi nal position,
leaving just enough space to get behind it.
Levelling
You are recommended to use a
spirit level on a shelf in one of
the ovens to check for level.
Place the cooker in its intended
position taking care not to twist
it within the gap between the
kitchen units as damage may
occur to the cooker or the units.
The rollers can be adjusted to
level the cooker. To adjust the
height of the rear of the cooker
use the levelling tool supplied
to turn the adjusting nuts at
the front bottom corners of the
cooker.
Adjust the height of the front
roller to level the cooker. Turn
clockwise to raise the cooker
and anticlockwise to lower.
When you are satisfi ed with the height and level, raise the
front of the cooker by one turn of the front roller adjuster.
Screw down the front feet to meet the fl oor. Screw the front
roller adjuster anticlockwise to raise the front roller so that
the front of the cooker is supported on the feet, not the
front roller, to prevent accidental movement of the cooker.
Leave the levelling tool in the storage drawer, so that the
customer can use it if they wish to move the cooker.
Gas Connection
Restraining device
A restraining device should be fi tted when the cooker is
connected to a fl exible gas supply. Any restraining device
should be secured to the fabric of the building and should
be able to be released so that the cooker can be pulled out
for cleaning and maintenance.
Flexible Gas Hose
A gas shut off valve must be fi tted between the gas supply
and the connection hose. The fl exible hose (not supplied
with the cooker) must be in accordance with the relevant
standards. If in doubt contact, your supplier.
The rear cover boxes limit the position of the supply point.
The house gas supply needs to terminate with a down
facing connection.
The appliance connection is located just below hotplate
level at the rear of the cooker. (‘A’ in the fi gure)
The inlet connection on the cooker is ISO 7-1 internal. If you
require a ISO 228-1 connection fi nd the ISO 7-1 to ISO 228-
1 connector in the conversion kit. Apply a suitable thread
sealing compound to the ISO 7-1 end.
… 46 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Falcon Toledo XT 110 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Falcon Toledo XT 110 in the language / languages: English, French as an attachment in your email.

The manual is 1,63 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info