Manual Fagor FIS-820 (page 10 of 44) (English, German, Dutch, French, Portuguese, Spanish)

473509

Zoom out

Zoom in

1/44

Instructions for Use

Important

• This appliance is not intended for use by persons (including

children) with reduced physical, sensory or mental

capabilities, or lack of experience and knowledge, unless

they have been given supervision or instruction concerning

use of the appliance by a person responsible for their safety.

• If you have bought this appliance to replace an old one

equipped with a lock that cannot be opened from inside

(lock, bolt), make sure that the lock is broken. This will make

it impossible for children to lock themselves inside

the appliance and suffocate.

• The appliance must be correctly connected to the mains

supply. (see: Connecting to the Mains Supply).

• If the food has strange smell or color, throw it away, because

it is very likely that it is spoiled and therefore dangerous to

eat.

• Disconnect the appliance from the power supply before

repairing it (only a qualified technician should repair it),

before cleaning and before replacing the light bulb.

• Do not defrost the appliance with other electric appliances

(as for example with hair dryer) and never scrape the frost

layer with sharp objects. Use only enclosed tools or tools

recommended by the manufacturer.

• For the sake of environment protection - be careful not to

damage the rear wall of the appliance (the condenser unit or

the tubes - for example when moving the appliance) or any

part of the refrigerating system inside the appliance.

• The refrigerating system of the appliance is filled with

refrigerant and oil, so when the appliance is damaged,

handle it with care and dispose it of in compliance with

environmental protecting precautions. (See We Care for the

Environment).

• If the supply cord is damaged, it must be replaced by the

manufacturer or his service agent or a qualified person in

order to avoid hazard.

• The rating plate is inside the appliance or outside on the rear

wall.

• Warning: Ventilation slots on the appliance or built-in

element should always be kept clean and unobstructed.

• Warning: Do not use any mechanical accessories when

thawing the refrigerator, except for those explicitly

recommended by the manufacturer.

• Warning: To prevent any pollution be careful not to damage

the insulation or refrigeration tubes at the rear wall during the

installation, cleaning and disposal of the appliance.

• Warning: Do not use any electrical devices inside the

appliance, except for those explicitly recommended by the

manufacturer.

Disposing of the Worn Out Appliance

• When your appliance finally wears out, dispose it of. If the

appliance has a lock, break it, in order to prevent eventual

accidents (danger of children get locked inside the appliance).

• The refrigerating system of the appliance is filled with

refrigerant and insulating substances which should be

separately treated and processed. Call your nearest

authorised service agent or specialised servicing centre. If

you don't find one, contact your local authorities or your

distributor. Be careful not to damage the tubes on the rear

wall of the appliance (danger of pollution).

• To avoid pollution of the environment make sure not to

damage the hose at the bottom of the appliance.

Environmental protection

This appliance’s packaging material is recyclable. Help recycle

it and protect the environment by dropping it off in the

municipal receptacles provided for this purpose.

Your appliance also contains a great amount of

recyclable material. It is marked with this label to

indicate that in countries that are a members of the

European Union the used appliances should not be

mixed with other waste. This way, the appliance recycling

organised by your manufacturer will be done under the best

possible conditions, in compliance with European Directive

2002/96/EC on Waste Electrical and Electronic Equipment.

Contact your town hall or your retailer for the used appliance

collection points closest to your home.

We thank you doing your part to protect the environment.

Placing and Installation

Choosing the Right Place

Place the appliance in a dry and regularly ventilated room.

Allowed ambient temperature depends on the model (class) of

the appliance and is stated on the rating plate of the appliance.

Never place the appliance near heat emitting devices (e.g.

cooker, radiator, water heater or similar devices) and do not

expose it to direct sunlight.

The appliance should be positioned at least 3 cm away from

the electric or gas cooker and at least 30 cm away from the oil

or coal stove. If this is not possible, use an appropriate

insulation.

Class Ambient temparature

SN (sub-normal) from + 10°C to + 32°C

N (normal) from + 16°C to + 32°C

ST (sub-tropical) from + 16°C to + 38°C

T (tropical) from + 16°C to + 43°C

Connection to Power Supply

Connect the appliance with the cable and plug to the power

supply socket outlet with a ground terminal (safety socket).

Required nominal voltage and frequency are indicated on the

rating plate.

The connection to the mains supply and earthing have to be

made according to current standards and regulations. The

appliance resists temporary voltage tolerance up to

-6 to +6 %.

Your appliance is compliant with European Directives as well

as their modifications.

Adjusting the height of the appliance

The appliance is equipped with four adjustable legs, so that the

height may be adjusted from 82 to 90 cm. The height must be

adjusted prior building the appliance into the opening slot, and

it should be set at such height that the top panel of the

appliance fits exactly below the kitchen worktop (see Mounting

Instructions).

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Fagor FIS-820 in the language / languages: English, German, Dutch, French, Portuguese, Spanish as an attachment in your email.

The manual is 3,26 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Fagor FIS-820 Manual

Product: