456781
14
Zoom out
Zoom in
Previous page
1/44
Next page
Instructions for Use
14
After cleaning return the appliance to its place, plug in the
mains power cord and fill with food.
Switch Off the Appliance When Not in Use
If you do not intend to use the appliance for a longer period of
time, disconnect the power supply, empty the appliance,
defrost it and clean it. Leave the door slightly open.
Trouble Shooting Guide
During the service, you can come across some troubles that in
most cases result from improper handling of the appliance and
can easy be eliminated.
The Appliance Fails to Operate After Connecting to the
Mains Supply
Check the voltage in the socket and see if the appliance is
switched on (green signal lamp is on).
Sound alarm, red signal lamp is on
If the temperature within the freezer is too high, it is signaled
by the red signal lamp and the sound alarm, which may be
switched off by pressing the alarm off button (3). When the
lamp goes off the interior of the freezer has again reached the
appropriate temperature.
Another increase of temperature within the freezer is again
signaled both by the red lamp and the sound alarm.
The reasons for this may be the following:
The door was frequently opened or it was left opened for too
long.
The door is not properly closed (the door may sag, the
gasket may be polluted or damaged).
Power supply has been interrupted for a longer period of
time.
Perhaps you have overloaded the appliance with fresh
foods.
The alarm sounds, red lamp is off
Excessive dust on the condenser or around the air circulation
openings in the bottom rail may set off the sound alarm. It may
be switched off by pressing the alarm off button (3).
Clean the condenser and the air circulation openings in the
bottom rail (consult the Section Cleaning of the Appliance).
Cooling system is operating continuously
Continued operation mode is on (yellow lamp is on).
Press the button (2) and switch the continued operation
mode off (yellow lamp goes off).
Insufficient cooling of compressor and condenser. This is
signaled by the sound alarm.
Check the air circulation through the bottom rail openings
and if necessary clean or vacuum the dust from the
condenser. See Section Cleaning and Maintenance.
The Door is Hard to Open
If you want to open the door that has just or recently been
closed, you may find it hard to open. The reason why this
happens is, that when you open the door, warm air gets into
the appliance and when it is cooling, the underpressure seals
the door. After few minutes (5-10), the door can easily be
opened.
Noise
Cooling in refrigerating-freezing appliances is enabled by the
cooling system with compressor, which produces noise. How
noisy the appliance is depends on where it is placed, how it is
used and
how old the appliance is.
During the operation of the compressor the noise of liquid
is heard and when the compressor is not operating, the
refrigerant flow is heard. This is a normal condition and it
has no influence whatsoever on the lifetime of the appliance.
After starting the appliance, the operation of the
compressor and the refrigerant flow may be louder, which
does not mean that something is wrong with the appliance
and it has no influence on the lifetime of the appliance.
Gradually the noise is reduced.
WE RESERVE THE RIGHT TO ALTER THE SPECIFICATIONS WITH NO INFLUENCE ON THE
OPERATION OF THE APPLIANCE.
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fagor CIV-820 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fagor CIV-820 in the language / languages: English, German, Dutch, French, Portuguese, Spanish as an attachment in your email.

The manual is 1,95 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info