485514
24
Zoom out
Zoom in
Previous page
1/82
Next page
english
22
4
5
Troubleshooting
Safety
You can solve the following problems yourself:
4.1 4.1 The oven is not heating up. Check it is
plugged in and switched on and that the fuse
has not blown. Select a higher temperature
setting.
4.2 The interior light is not working. Change the
bulb or replace the fuse.
4.3 Smoke is coming out during cooking. Turn
the temperature down and/or clean the oven.
4.4 The pyrolysis cleaning process is not
being carried out. Ensure the door
is correctly closed. Locking system or
temperature sensor failure. Call the Technical
Service.
4.5 A beep is sounding. The selected
temperature setting has been reached. The
The oven must be installed by an authorised
installer in accordance with the manufacturer’s
instructions and diagrams.
The electrical installation must be dimensioned
for the maximum power indicated on the
reference plate and the electrical socket must
have a regulatory earth connection.
The mains circuit supplying the oven must have
a single-pole cut-off switch with at least 3 mm
between contacts.
If the power cord is damaged, it must be
replaced by the after-sales technical service or
by similarly qualifi ed staff, to avoid hazard.
Ensure the appliance is unplugged from the
mains before replacing the oven lamp, to avoid
electric shock.
Do not use abrasive cleaning products or metal
scouring pads to clean the oven door, as they
could scratch the surface and cause the glass
to shatter.
remaining accessories so that they provide
leverage to lift up the glass (3.7.3). Remove
the glass (3.7.4), clean it and dry it with a
cloth (3.7.5). If necessary, remove the whole
glass panel unit inside the door. This unit
consists of either one or two glass panels,
depending on the model, with a black stop
in each corner. To remove them, place your
hand under the door and pull upwards
(3.7.6). When you have taken out the unit,
remove the stops to clean the glass panels
(3.7.7).
When the glass panels are clean (3.7.8) fi t
them onto the rubber stops again, with the
stud facing upwards (3.7.9) and replace the
glass panels so that the letters “L” (left) and
“R” (right) are beside the hinges (3.7.10).
Lastly, place the remaining glass panel so
that the word PYROLYTIC can be read
(3.7.11). Remove the stops (3.7.12) and
close the door.
Warnings:
Make sure the oven is switched off.
Allow the glass to cool down before
removing it.
Never use steam cleaning machines.
3.8 Cleaning the outside of the oven. Use
neutral cleaning products. Dry the oven well
with a soft cloth.
cooking cycle is complete.
4.6 The oven makes a noise after cooking.
This is normal, as the fan keeps running until
the temperature inside and outside the oven
is reduced.
4.7 Failure warnings.
Temperature sensor failure.
Door blocked (4.7.1).
Pyrolysis cannot be carried out.
Door block failure.
Software Failure
Power cut during cooking.
The oven automatically switches
off as it has been functioning for
several hours (4.7.2).
Do not try to repair the oven yourself. Call
the technical assistance service.
24


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fagor 6H-760AX at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fagor 6H-760AX in the language / languages: English, German, Dutch, French, Portuguese, Spanish as an attachment in your email.

The manual is 1,75 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info