751519
3
Zoom out
Zoom in
Previous page
1/100
Next page
3
Recommendations
and suggestions
The Instructions for Use apply
to several versions of this appli-
ance.Accordingly,youmaynd
descriptions of individual features
thatdonotapplytoyourspecic
appliance.
The manufacturer will not be
held liable for any damages re-
sulting from incorrect or improper
installation.
The minimum safety distance
between the cooker top and
the extractor hood is 650 mm
(some models can be installed
at a lower height, please refer
to the paragraphs on working
dimensions and installation).
Check that the mains voltage
corresponds to that indicated on
theratingplatexedtotheinside
of the hood.
For Class I appliances, check
that the domestic power supply
guarantees adequate earthing.
Connect the extractor to the
exhaust ue through a pipe of
minimum diameter 120 mm. The
routeoftheuemustbeasshort
as possible.
Do not connect the extractor
hood to exhaust ducts carrying
combustion fumes (boilers, re-
places, etc.).
If the extractor is used in conjunc-
tion with non-electrical appliances
(e.g. gas burning appliances), a
sufcientdegreeofaerationmust
be guaranteed in the room in
ordertopreventthebackowof
exhaust gas. The kitchen must
have an opening communicating
directly with the open air in order
to guarantee the entry of clean air.
When the cooker hood is used
in conjunction with appliances
supplied with energy other than
electric, the negative pressure in
the room must not exceed 0,04
mbar to prevent fumes being
drawn back into the room by the
cooker hood.
In the event of damage to the
power cable, it must be replaced
by the manufacturer or by the
technical service department, in
order to prevent any risks.
If the instructions for installation
for the gas hob specify a greater
distancespeciedabove,thishas
to be taken into account. Regu-
lations concerning the discharge
of air have to be fullled.
Use only screws and small parts
in support of the hood.
Warning: Failure to install the
screws or xing device in ac-
cordance with these instructions
may result in electrical hazards.
Connect the hood to the mains
through a two-pole switch having
a contact gap of at least 3 mm.
Use
The extractor hood has been
designed exclusively for domestic
use to eliminate kitchen smells.
Never use the hood for purposes
other than for which it has been
designed.
Never leave high naked ames
under the hood when it is in
operation.
EN
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Faber Skypad 2.0 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Faber Skypad 2.0 in the language / languages: All languages as an attachment in your email.

The manual is 4,75 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Faber Skypad 2.0

Faber Skypad 2.0 Installation Guide - All languages - 16 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info