560682

FAAC S450H Manual

7
Zoom out
Zoom in
Previous page
1/11
Next page
6
a
ENGLISH
Close the gate leaf and install the front fitting on the rod as
shown in Fig. 11 re.
b.
Establish the fixing position of the front fitting on the leaf
and mark the fixing points (Fig. 12)
(the operator must be
perfectly level).
Disassemble the operator from the front fixing to avoid
damaging the rod when the front fixing is installed on the
gate.
Weld the front fixing directly on the leaf or screw it by means
of threaded inserts.
If an opening mechanical stop on ground is not installed,
spacers can be used (Fig. 1 re.
g). Remove the front
articulated joint and insert on the rod the number of spacers
required to reach the desired opening angle (Fig. 14).
10.
11.
12.
13.
14.
If an external mechanical
stop point at closure is pre-
sent, remove the rod comple-
tely and then insert it 5 mm.
Fig. 12
Fig. 13
Fig. 15
Fig. 16
MINIMUM
BENDING
RADIUS
60 mm
MINIMUM
BENDING
RADIUS
60 mm
Fig. 17
Fig. 14
Secure the operator to the front fixing (Fig. 15).
Remove the bleed screw (Fig.16 ref. a) paying special
attention to leave the sealing O-Ring in its seat
Install the metallic protection cover as shown in Fig. 16, insert
and tighten both tie-rods
Connect the cable to the operator using the two screws
supplied, as shown in Fig. 17.
15.
16.
17.
18.
… 7 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for FAAC S450H at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of FAAC S450H in the language / languages: English as an attachment in your email.

The manual is 1,84 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of FAAC S450H

FAAC S450H User Manual - Dutch - 10 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info